Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The oil pump is driven by the
Options- A. camshaft
- B. alternator shaft
- C. crankshaft via drive belt
- D. crankshaft directly
- Correct Answer
- crankshaft directly
- 1. A traction control system (TCS) in automobiles controls the
Options- A. vibrations on the steering wheel
- B. engine power during acceleration
- C. torque that is transmitted by the tyres to the road surface
- D. stopping distance in case of emergency Discuss
- 2. The compression ratio in petrol engine is kept less than in Diesel engine because
Options- A. it makes petrol engines lighter
- B. higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
- C. less compression ratio gives better performance
- D. it is just customary to have less compression ratio in petrol engines Discuss
- 3. The aluminium alloy is used in cylinder blocks because
Options- A. it is lighter and have good heat dissipation characteristics
- B. material cost is low
- C. it does not require any cylinder liners
- D. the piston is also made of aluminium alloy Discuss
- 4. Incorrect steering axis inclination (S.A.I.) causes
Options- A. tendency to assume toe-out orientation
- B. generation of a braking effect at tight corners
- C. poor recovery of the steering wheel after making a turn
- D. the vehicle to pull to the side of lesser inclination Discuss
- 5. The operation of removing trapped air from the hydraulic braking system is known as
Options- A. trapping
- B. tapping
- C. bleeding
- D. cleaning Discuss
- 6. In a ventilated disc brake,
Options- A. a duct directs air towards the caliper for cooling while the vehicle is moving
- B. caliper is covered with cooling fins
- C. disc contains many small holes for optimum cooling performance
- D. disc contains radial vanes between its rubbing surfaces for optimum cooling performance Discuss
- 7. In automobiles G.V.W. refers to
Options- A. gross vehicle width
- B. gross vehicle weight
- C. gross vehicle wheel base
- D. gross vehicle wheel track Discuss
- 8. The petrol engines are also known as
Options- A. spark ignition (S.I.) engines
- B. compression ignition (C.I.) engines
- C. steam engines
- D. none of these Discuss
- 9. If the level of tension in the belt is too high, it can result in a loss of power or in bending of the rotating shaft or crankshaft.
Options- A. Correct
- B. Incorrect Discuss
- 10. If the air-fuel mixture ignites before the spark takes place at spark plug, the condition is called
Options- A. detonation
- B. ignition
- C. pre-ignition
- D. rumble Discuss
Automobile Engineering problems
Search Results
Correct Answer: torque that is transmitted by the tyres to the road surface
Correct Answer: higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
Correct Answer: it is lighter and have good heat dissipation characteristics
Correct Answer: poor recovery of the steering wheel after making a turn
Correct Answer: bleeding
Correct Answer: disc contains radial vanes between its rubbing surfaces for optimum cooling performance
Correct Answer: gross vehicle weight
Correct Answer: spark ignition (S.I.) engines
Correct Answer: Correct
Correct Answer: pre-ignition
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.