logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Automobile Engineering See What Others Are Saying!
  • Question
  • The compression ratio in petrol engine is kept less than in Diesel engine because


  • Options
  • A. it makes petrol engines lighter
  • B. higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
  • C. less compression ratio gives better performance
  • D. it is just customary to have less compression ratio in petrol engines

  • Correct Answer
  • higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition 


  • More questions

    • 1. According to Bernoulli's equation

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. If the condenser temperature is kept constant, the coefficient of performance of a refrigeration cycle increases with the increase in evaporator temperature.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 3. When the piston is at T.D.C, the volume above the piston in the combustion chamber is the

    • Options
    • A. clearance volume
    • B. cylinder volume
    • C. exhaust volume
    • D. none of these
    • Discuss
    • 4. During dehumidification process, the relative humidity

    • Options
    • A. remains constant
    • B. increases
    • C. decreases
    • Discuss
    • 5. A diamond locating pin is used in jigs and fixtures because

    • Options
    • A. diamond is very hard and wear resistant
    • B. it occupies very little space
    • C. it helps in assembly with tolerance on centre distance
    • D. it has a long life
    • Discuss
    • 6. The maximum temperature in a gas turbine is

    • Options
    • A. 200°C
    • B. 500°C
    • C. 700°C
    • D. 1000°C
    • Discuss
    • 7. The flow at critical depth in an open channel is called torrential flow.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 8. Glazing in grinding wheels takes place when the

    • Options
    • A. wheel is too hard or wheel revolves at a very high speed
    • B. wheel is too soft or wheel revolves at a very slow speed
    • C. wheel is too hard and wheel revolves at very slow speed
    • D. wheel is too soft and wheel revolves at a very high speed
    • Discuss
    • 9. The swing diameter over carriage is always less than the swing diameter over bed.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 10. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment