Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The operation of removing trapped air from the hydraulic braking system is known as
Options- A. trapping
- B. tapping
- C. bleeding
- D. cleaning
- Correct Answer
- bleeding
- 1. The tilting of the front wheels away from the vertical, when viewed from the front of the car, is called
Options- A. camber
- B. caster
- C. toe-in
- D. toe-out Discuss
- 2. In a unit type body (frameless body) design, the sheet metal parts are welded together, forming a frame work to which outer skin is attached.
Options- A. True
- B. False Discuss
- 3. A zinc diffusion process is called
Options- A. galvanising
- B. anodising
- C. parkerising
- D. sherardizing Discuss
- 4. The accuracy of micrometers, calipers, dial indicators can be checked by a
Options- A. feeler gauge
- B. slip gauge
- C. ring gauge
- D. plug gauge Discuss
- 5. The type of file used for a wood work is
Options- A. single-cut file
- B. double cut file
- C. rasp-cut file
- D. any one of these Discuss
- 6. Incorrect steering axis inclination (S.A.I.) causes
Options- A. tendency to assume toe-out orientation
- B. generation of a braking effect at tight corners
- C. poor recovery of the steering wheel after making a turn
- D. the vehicle to pull to the side of lesser inclination Discuss
- 7. The aluminium alloy is used in cylinder blocks because
Options- A. it is lighter and have good heat dissipation characteristics
- B. material cost is low
- C. it does not require any cylinder liners
- D. the piston is also made of aluminium alloy Discuss
- 8. The compression ratio in petrol engine is kept less than in Diesel engine because
Options- A. it makes petrol engines lighter
- B. higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
- C. less compression ratio gives better performance
- D. it is just customary to have less compression ratio in petrol engines Discuss
- 9. A traction control system (TCS) in automobiles controls the
Options- A. vibrations on the steering wheel
- B. engine power during acceleration
- C. torque that is transmitted by the tyres to the road surface
- D. stopping distance in case of emergency Discuss
- 10. The oil pump is driven by the
Options- A. camshaft
- B. alternator shaft
- C. crankshaft via drive belt
- D. crankshaft directly Discuss
Automobile Engineering problems
Search Results
Correct Answer: camber
Correct Answer: True
Correct Answer: sherardizing
Correct Answer: slip gauge
Correct Answer: rasp-cut file
Correct Answer: poor recovery of the steering wheel after making a turn
Correct Answer: it is lighter and have good heat dissipation characteristics
Correct Answer: higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
Correct Answer: torque that is transmitted by the tyres to the road surface
Correct Answer: crankshaft directly
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.