logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Workshop Technology See What Others Are Saying!
  • Question
  • Surface plate is used to check the trueness of flat surfaces.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • More questions

    • 1. In a domestic vapour compression refrigerator, the refrigerant commonly used is

    • Options
    • A. CO2
    • B. Ammonia
    • C. R-12
    • D. all of these
    • Discuss
    • 2. A supercharged engine as compared to an ordinary engine

    • Options
    • A. is lighter
    • B. requires smaller foundations
    • C. consumes less lubricating oil
    • D. all of these
    • Discuss
    • 3. Lancashire boiler has __________ internal flue tubes.

    • Options
    • A. one
    • B. two
    • C. three
    • D. four
    • Discuss
    • 4. P.M.T.S. (Predetermined Motion Time Systems) include

    • Options
    • A. M.T.M. (Method Time Measurement)
    • B. W.F.S. (Work Factor Systems)
    • C. B.M.T.S. (Basic Motion Time Study)
    • D. all of these
    • Discuss
    • 5. The cutting speed is minimum while machining __________ with a high speed steel tool.

    • Options
    • A. cast iron
    • B. mild steel
    • C. brass
    • D. aluminium
    • Discuss
    • 6. The heat rejection factor (HRF) is given by

    • Options
    • A. 1 + C.O.P
    • B. 1 - C.O.P.
    • C.
    • D.
    • Discuss
    • 7. The shear force of a cantilever beam of length l carrying a uniformly distributed load of w per unit length is __________ at the fixed end.

    • Options
    • A. zero
    • B. wl/4
    • C. wl/2
    • D. wl
    • Discuss
    • 8. A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as

    • Options
    • A. back pressure turbine
    • B. pass out turbine
    • C. low pressure turbine
    • D. impulse turbine
    • Discuss
    • 9. According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)

    • Options
    • A. IP = IG + Ah2
    • B. IP = IG - Ah2
    • C. IP = IG / Ah2
    • D. IP = Ah2 / IG
    • Discuss
    • 10. In order to obtain a surface finish in the range of 0.75 ?m to 1.25 ?m , the operation used is called.

    • Options
    • A. grinding
    • B. lapping
    • C. honing
    • D. buffing
    • Discuss


    Comments

    There are no comments.

Enter a new Comment