logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Workshop Technology Comments

  • Question
  • The fullers are used


  • Options
  • A. for finishing flat surfaces
  • B. for necking down a piece of work
  • C. for punching a hole
  • D. to finish the punched hole

  • Correct Answer
  • for necking down a piece of work 


  • Workshop Technology problems


    Search Results


    • 1. Which of the following methods can be used for manufacturing 2 metre long seamless metallic tubes?

    • Options
    • A. Drawing
    • B. Extrusion
    • C. Rolling
    • D. Extrusion and rolling
    • Discuss
    • 2. In arc welding, the electric arc is produced between the work and the electrode by

    • Options
    • A. voltage
    • B. flow of current
    • C. contact resistance
    • D. all of these
    • Discuss
    • 3. In a four high rolling mill, there are four rolls out of which

    • Options
    • A. one is working roll and three are backing up rolls
    • B. two are working rolls and two are backing up rolls
    • C. three are working rolls and one is backing up roll
    • D. all of the four are working rolls
    • Discuss
    • 4. The purpose of a riser is to

    • Options
    • A. deliver molten metal into the mould cavity
    • B. act as a reservoir for the molten metal
    • C. feed the molten metal to the casting in order to compensate for the shrinkage
    • D. deliver the molten metal from pouring basin to gate
    • Discuss
    • 5. Blanking and piercing operations can be performed simultaneously in a

    • Options
    • A. simple die
    • B. progressive die
    • C. compound die
    • D. combination die
    • Discuss
    • 6. The cross-section of a chisel is usually

    • Options
    • A. rectangular
    • B. square
    • C. hexagonal
    • D. octagonal
    • Discuss
    • 7. A plug gauge is used to check the diameter of shafts and studs.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 8. The property of sand due to which it evolves a great amount of steam and other gases is called

    • Options
    • A. collapsibility
    • B. permeability
    • C. cohesiveness
    • D. adhesiveness
    • Discuss
    • 9. In back-hand welding, the angle between the welding torch and the work is kept as

    • Options
    • A. 30°-40°
    • B. 40°-50°
    • C. 50°-60°
    • D. 60°-70°
    • Discuss
    • 10. A saw which cuts wood during the return stroke of the saw is known as

    • Options
    • A. push saw
    • B. pull saw or draw saw
    • Discuss


    Comments

    There are no comments.

Enter a new Comment