logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Workshop Technology Comments

  • Question
  • In a four high rolling mill, there are four rolls out of which


  • Options
  • A. one is working roll and three are backing up rolls
  • B. two are working rolls and two are backing up rolls
  • C. three are working rolls and one is backing up roll
  • D. all of the four are working rolls

  • Correct Answer
  • two are working rolls and two are backing up rolls 


  • Workshop Technology problems


    Search Results


    • 1. The purpose of a riser is to

    • Options
    • A. deliver molten metal into the mould cavity
    • B. act as a reservoir for the molten metal
    • C. feed the molten metal to the casting in order to compensate for the shrinkage
    • D. deliver the molten metal from pouring basin to gate
    • Discuss
    • 2. Blanking and piercing operations can be performed simultaneously in a

    • Options
    • A. simple die
    • B. progressive die
    • C. compound die
    • D. combination die
    • Discuss
    • 3. In a hot chamber die casting machine

    • Options
    • A. melting pot is separate from the machine
    • B. melting pot is an integral part of the machine
    • C. melting pot may have any location
    • D. high temperature and pressure is used
    • Discuss
    • 4. Which of the following welding process uses non-consumable electrodes?

    • Options
    • A. TIG welding
    • B. MIG welding
    • C. Manual arc welding
    • D. Submerged arc welding
    • Discuss
    • 5. In a centrifugal casting method, the impurities are collected in the centre of the casting.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 6. In arc welding, the electric arc is produced between the work and the electrode by

    • Options
    • A. voltage
    • B. flow of current
    • C. contact resistance
    • D. all of these
    • Discuss
    • 7. Which of the following methods can be used for manufacturing 2 metre long seamless metallic tubes?

    • Options
    • A. Drawing
    • B. Extrusion
    • C. Rolling
    • D. Extrusion and rolling
    • Discuss
    • 8. The fullers are used

    • Options
    • A. for finishing flat surfaces
    • B. for necking down a piece of work
    • C. for punching a hole
    • D. to finish the punched hole
    • Discuss
    • 9. The cross-section of a chisel is usually

    • Options
    • A. rectangular
    • B. square
    • C. hexagonal
    • D. octagonal
    • Discuss
    • 10. A plug gauge is used to check the diameter of shafts and studs.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss


    Comments

    There are no comments.

Enter a new Comment