logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Theory of machines Comments

  • Question
  • The two elements of a pair are said to form a __________ when they permit relative motion between them.


  • Options
  • A. open pair
  • B. kinematic pair

  • Correct Answer
  • kinematic pair 


  • Theory of machines problems


    Search Results


    • 1. The sliding pairs, turning pairs and screw pairs form lower pairs.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. A pair of friction discs is an example of rolling pair.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the

    • Options
    • A. pitch circle
    • B. base circle
    • C. pitch curve
    • D. prime circle
    • Discuss
    • 4. A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located at a distance of 2 mm from the axis of the shaft. When the shaft is allowed to vibrate in its natural bow-shaped mode, it has a frequency of vibration of 10 rad/s. When the shaft is rotated at 300 r.p.m., it will whirl with a radius of

    • Options
    • A. 2 mm
    • B. 2.22 mm
    • C. 2.50 mm
    • D. 3.0 mm
    • Discuss
    • 5. The primary unbalanced force is maximum when the angle of inclination of the crank with the line of stroke is

    • Options
    • A. 0° and 90°
    • B. 0° and 180°
    • C. 90° and 180°
    • D. 180° and 360°
    • Discuss
    • 6. The electrodes used in spot welding have a tip of

    • Options
    • A. stainless steel
    • B. aluminium
    • C. copper
    • D. brass
    • Discuss
    • 7. The blank diameter used in thread rolling will be

    • Options
    • A. equal to minor diameter of the thread
    • B. equal to pitch diameter of the thread
    • C. a little larger than the minor diameter of the thread
    • D. a little larger than the pitch diameter of the thread
    • Discuss
    • 8. Metal patterns are used for

    • Options
    • A. small castings
    • B. large castings
    • C. complicated castings
    • D. large scale production of castings
    • Discuss
    • 9. The draft or taper allowance on casting is generally

    • Options
    • A. 1 to 2 mm/m
    • B. 2 to 5 mm/m
    • C. 5 to 10 mm/m
    • D. 10 to 15 mm/m
    • Discuss
    • 10. A taper provided on the pattern for its easy and clean withdrawl from the mould is known as

    • Options
    • A. machining allowance
    • B. draft allowance
    • C. shrinkage allowance
    • D. distortion allowance
    • Discuss


    Comments

    There are no comments.

Enter a new Comment