logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Theory of machines See What Others Are Saying!
  • Question

  • For a twin cylinder V-engine, the crank positions for primary reverse cranks and secondary direct cranks are shown in the below figure. The engine is a
    For a twin cylinder V-engine, the crank positions for primary reverse cranks and secondary direct cr


  • Options
  • A. 30° V-engine
  • B. 60° V-engine
  • C. 120° V-engine
  • D. 150° V-engine

  • Correct Answer
  • 30° V-engine 

    • More questions

    • 1. The specific weight is also known as weight density.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 2. Which of the following material has maximum malleability?

    • Options
    • A. Lead
    • B. Soft steel
    • C. Wrought iron
    • D. Copper
      • Discuss
    • 3. A petrol that detonates easily is called

    • Options
    • A. high octane petrol
    • B. low octane petrol
    • C. unleaded petrol
    • D. blended fuel
      • Discuss
    • 4. A tool used to withdraw a drill from the sleeve is called

    • Options
    • A. drill remover
    • B. drill puller
    • C. drift
    • D. drill drawer
      • Discuss
    • 5. The length of hacksaw blade is the distance between the outside edges of the holes which fits over the pins.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 6. Euler's formula holds good only for

    • Options
    • A. short columns
    • B. long columns
    • C. both short and long columns
    • D. weak columns
      • Discuss
    • 7. Surface plate is used to check the trueness of flat surfaces.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. Follow-up prescribes the sequence of operations to be followed.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 9. An over-inflated tyre will wear the tread most near the

    • Options
    • A. edges
    • B. corners
    • C. centre
    • D. none of these
      • Discuss
    • 10. A beam encastered at both the ends is called

    • Options
    • A. simply supported beam
    • B. fixed beam
    • C. cantilever beam
    • D. continuous beam
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.