Discussion
Home ‣ Mechanical Engineering ‣ Machine Design Comments
- Question
The load cup of a screw jack is made separate from the head of the spindle to
Options- A. enhance the load carrying capacity of the jack
- B. reduce the effort needed for lifting the working load
- C. prevent the rotation of load being lifted
- D. reduce the value of frictional torque
- Correct Answer
- prevent the rotation of load being lifted
- 1. Surface endurance limit of gear material is dependent upon its
Options- A. elastic strength
- B. yield strength
- C. brinell hardness number
- D. toughness Discuss
- 2. Circumferential joint in boilers is used to get the required length of a boiler.
Options- A. True
- B. False Discuss
- 3. According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test.
Options- A. True
- B. False Discuss
- 4. In order to obtain the bolts of uniform strength, an axial hole is drilled through the head as far as the threaded portion such that the area of shank becomes equal to the root area of the thread.
Options- A. True
- B. False Discuss
- 5. A transmission shaft includes
Options- A. counter shaft
- B. line shaft
- C. over head shaft
- D. all of these Discuss
- 6. A crankshaft is a __________ shaft.
Options- A. transmission
- B. machine Discuss
- 7. Which of the following statement is wrong?
Options- A. The power transmitted by V-belts is less than flat belts for the same coefficient of friction, arc of contact and allowable tension in the belts
- B. The V-belt drive is used with large centre distance
- C. The V-belt may be operated in either direction with tight side of the belt at the top or bottom
- D. The ratio of driving tensions in V-belt drive is more than flat belt drives Discuss
- 8. The ball bearings are provided with a cage
Options- A. to reduce friction
- B. to facilitate slipping of balls
- C. to prevent the lubricant from flowing out
- D. to maintain the balls at a fixed distance apart Discuss
- 9. The centre distance between two meshing involute gears is equal to
Options- A.
- B.
- C.
- D.
Discuss
- 10. The toughness of a material __________ when it is heated.
Options- A. increases
- B. decreases
- C. does not change Discuss
Machine Design problems
Search Results
Correct Answer: brinell hardness number
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: all of these
Correct Answer: machine
Correct Answer: The V-belt drive is used with large centre distance
Correct Answer: to maintain the balls at a fixed distance apart
Correct Answer:
Correct Answer: decreases
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.