logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Machine Design Comments

  • Question
  • The value of stress concentration factor depends upon


  • Options
  • A. material of the part
  • B. geometry of the part
  • C. material and geometry of the part
  • D. none of these

  • Correct Answer
  • material and geometry of the part 


  • Machine Design problems


    Search Results


    • 1. The resistance to fatigue of a material is measured by

    • Options
    • A. elastic limit
    • B. Young's modulus
    • C. ultimate tensile strength
    • D. endurance limit
    • Discuss
    • 2. A column is known as a long column if the slenderness ratio is

    • Options
    • A. 40
    • B. 50
    • C. 70
    • D. 100
    • Discuss
    • 3. The pipe joint mostly used for pipes carrying water at low pressures is

    • Options
    • A. socket joint
    • B. nipple joint
    • C. union joint
    • D. spigot and socket joint
    • Discuss
    • 4. The square threads are not so strong as V-threads but they offer less frictional resistance to motion than Whitworth threads.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 5. The velocity of sliding __________ the distance of the point of contact from the pitch point.

    • Options
    • A. is directly proportional to
    • B. is inversely proportional to
    • C. is equal to cos ? multiplied by
    • D. does not depend upon
    • Discuss
    • 6. For unequal width of butt straps, the thickness of butt straps are

    • Options
    • A. 0.75 t for wide strap on the inside and 0.625 t for narrow strap on the outside
    • B. 0.75 t for narrow strap on the inside and 0.625 t for wide strap on the outside
    • C. 0.75 t for both the straps on the inside and outside
    • D. 0.625 t for both the straps on the inside and outside
    • Discuss
    • 7. According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)

    • Options
    • A. d2 x ? x n
    • B. 1.875 x d2 x ? x n
    • C. 2 x d2 x ? x n
    • D. 3 x d2x ? x n
    • Discuss
    • 8. Which of the following statement is correct for gears?

    • Options
    • A. The addendum is less than dedendum
    • B. The pitch circle diameter is equal to the product of module and number of teeth
    • C. The pitch circle is always greater than the base circle
    • D. all of the above
    • Discuss
    • 9. Slenderness ratio is the ratio of

    • Options
    • A. maximum size of column to minimum size of column
    • B. width of column to depth of column
    • C. effective length of column to least radius of gyration of the column
    • D. effective length of column to width of column
    • Discuss
    • 10. Screws used for power transmission should have

    • Options
    • A. Low efficiency
    • B. high efficiency
    • C. very fine threads
    • D. strong teeth
    • Discuss


    Comments

    There are no comments.

Enter a new Comment