logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Machine Design Comments

  • Question
  • The square threads are not so strong as V-threads but they offer less frictional resistance to motion than Whitworth threads.


  • Options
  • A. Correct
  • B. Incorrect

  • Correct Answer
  • Correct 


  • Machine Design problems


    Search Results


    • 1. The velocity of sliding __________ the distance of the point of contact from the pitch point.

    • Options
    • A. is directly proportional to
    • B. is inversely proportional to
    • C. is equal to cos ? multiplied by
    • D. does not depend upon
    • Discuss
    • 2. A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where ? = Stress for a plate with no hole i.e. nominal stress)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)

    • Options
    • A. d
    • B. 1.5 d
    • C. 2 d
    • D. 2.5 d
    • Discuss
    • 4. In second type of levers,

    • Options
    • A. load is in between the fulcrum and effort
    • B. effort is in between the fulcrum and load
    • C. fulcrum is in between the load and effort
    • D. none of these
    • Discuss
    • 5. Stress concentration is caused due to

    • Options
    • A. variations in load acting on a member
    • B. variations in properties of materials in a member
    • C. abrupt change of cross-section
    • D. all of these
    • Discuss
    • 6. The pipe joint mostly used for pipes carrying water at low pressures is

    • Options
    • A. socket joint
    • B. nipple joint
    • C. union joint
    • D. spigot and socket joint
    • Discuss
    • 7. A column is known as a long column if the slenderness ratio is

    • Options
    • A. 40
    • B. 50
    • C. 70
    • D. 100
    • Discuss
    • 8. The resistance to fatigue of a material is measured by

    • Options
    • A. elastic limit
    • B. Young's modulus
    • C. ultimate tensile strength
    • D. endurance limit
    • Discuss
    • 9. The value of stress concentration factor depends upon

    • Options
    • A. material of the part
    • B. geometry of the part
    • C. material and geometry of the part
    • D. none of these
    • Discuss
    • 10. For unequal width of butt straps, the thickness of butt straps are

    • Options
    • A. 0.75 t for wide strap on the inside and 0.625 t for narrow strap on the outside
    • B. 0.75 t for narrow strap on the inside and 0.625 t for wide strap on the outside
    • C. 0.75 t for both the straps on the inside and outside
    • D. 0.625 t for both the straps on the inside and outside
    • Discuss


    Comments

    There are no comments.

Enter a new Comment