Discussion
Home ‣ Mechanical Engineering ‣ Hydraulic Machines Comments
- Question
Which of the following pump is preferred for flood control and irrigation applications?
Options- A. Centrifugal pump
- B. Axial flow pump
- C. Mixed flow pump
- D. Reciprocating pump
- Correct Answer
- Axial flow pump
- 1. Manometric head, in case of a centrifugal pump, is equal to
Options- A. Suction lift + Loss of head in suction pipe due to friction + Delivery lift + Loss of head in delivery pipe due to friction + Velocity head in the delivery pipe
- B. Workdone per kN of water - Losses within the impeller
- C. Energy per kN at outlet of impeller - Energy per kN at inlet of impeller
- D. all of the above Discuss
- 2. Power required to drive a centrifugal pump is directly proportional to __________ of its impeller.
Options- A. diameter
- B. square of diameter
- C. cube of diameter
- D. fourth power of diameter Discuss
- 3. The specific speed from 160 to 500 r.p.m. of a centrifugal pump indicates that the pump is
Options- A. slow speed with radial flow at outlet
- B. medium speed with radial flow at outlet
- C. high speed with radial flow at outlet
- D. high speed with axial flow at outlet Discuss
- 4. The maximum number of jets, generally, employed in an impulse turbine without jet interference are
Options- A. two
- B. four
- C. six
- D. eight Discuss
- 5. The discharge of a double acting reciprocating pump is (where L = Length of stroke, A = Cross-sectional area of piston, and N = Speed of crank in r.p.m.)
Options- A. L.A.N
- B. 2 L.A.N
- C.
- D.
Discuss
- 6. In a Kaplan turbine runner, the number of blades are generally between
Options- A. 2 to 4
- B. 4 to 8
- C. 8 to l6
- D. 16 to 24 Discuss
- 7. In an impulse turbine, the jet of water impinges on the bucket with a low velocity and after flowing over the vanes, leaves with a high velocity.
Options- A. True
- B. False Discuss
- 8. The discharge of a centrifugal pump working under constant head __________ with the speed.
Options- A. increases
- B. decreases Discuss
- 9. Which of the following turbine is preferred for 0 to 25 m head of water?
Options- A. Pelton wheel
- B. Kaplan turbine
- C. Francis turbine
- D. none of these Discuss
- 10. Work done by a turbine __________ upon the weight of water flowing per second.
Options- A. depends
- B. does not depend Discuss
Hydraulic Machines problems
Search Results
Correct Answer: all of the above
Correct Answer: fourth power of diameter
Correct Answer: high speed with axial flow at outlet
Correct Answer: six
Correct Answer:
Correct Answer: 4 to 8
Correct Answer: False
Correct Answer: increases
Correct Answer: Kaplan turbine
Correct Answer: depends
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.