logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • In order to prevent crushing of masonry at the base of the dam, the maximum stress should be __________ the permissible stress of the soil.


  • Options
  • A. equal to
  • B. less than
  • C. more than

  • Correct Answer
  • less than 


  • Strength of Materials problems


    Search Results


    • 1. For a beam, as shown in the below figure, the maximum deflection is .

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. In the torsion equation the term J/R is called

    • Options
    • A. shear modulus
    • B. section modulus
    • C. polar modulus
    • D. none of these
    • Discuss
    • 3. The maximum stress produced in a bar of tapering section is at

    • Options
    • A. smaller end
    • B. larger end
    • C. middle
    • D. anywhere
    • Discuss
    • 4. The energy stored in a body when strained within elastic limit is known as

    • Options
    • A. resilience
    • B. proof resilience
    • C. strain energy
    • D. impact energy
    • Discuss
    • 5. A masonry dam may fail due to

    • Options
    • A. tension in the masonry of the dam and its base
    • B. overturning of the dam
    • C. crushing of masonry at the base of the dam
    • D. any one of the above
    • Discuss
    • 6. Strain resetters are used to

    • Options
    • A. measure shear strain
    • B. measure linear strain
    • C. measure volumetric strain
    • D. relieve strain
    • Discuss
    • 7. A steel bar of 5 mm is heated from 15° C to 40° C and it is free to expand. The bar Will induce

    • Options
    • A. no stress
    • B. shear stress
    • C. tensile stress
    • D. compressive stress
    • Discuss
    • 8. The strain energy stored in a solid circular shaft subjected to shear stress (?) is (where C = Modulus of rigidity for the shaft material)

    • Options
    • A. x Volume of shaft
    • B. x Volume of shaft
    • C. x Volume of shaft
    • D. x Volume of shaft
    • Discuss
    • 9. The deformation per unit length is called

    • Options
    • A. tensile stress
    • B. compressive stress
    • C. shear stress
    • D. strain
    • Discuss
    • 10. A vertical column has two moments of inertia (i.e. Ixx and Iyy ). The column will tend to buckle in the direction of the

    • Options
    • A. axis of load
    • B. perpendicular to the axis of load
    • C. maximum moment of inertia
    • D. minimum moment of inertia
    • Discuss


    Comments

    There are no comments.

Enter a new Comment