Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
For a beam, as shown in the below figure, when the load W is applied in the centre of the beam, the maximum deflection is
Options- A.
- B.
- C.
- D.
- Correct Answer
-
- 1. The bending stress in a beam is __________ section modulus.
Options- A. directly proportional to
- B. inversely proportional to Discuss
- 2. Strain energy is the
Options- A. energy stored in a body when strained within elastic limits
- B. energy stored in a body when strained upto the breaking of a specimen
- C. maximum strain energy which can be stored in a body
- D. proof resilience per unit volume of a material Discuss
- 3. When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the
Options- A. top layer
- B. bottom layer
- C. neutral axis
- D. every cross-section Discuss
- 4. In order to know whether a column is long or short, we must know its slenderness ratio.
Options- A. True
- B. False Discuss
- 5. Resilience is the
Options- A. energy stored in a body when strained within elastic limits
- B. energy stored in a body when strained upto the breaking of the specimen
- C. maximum strain energy which can be stored in a body
- D. none of the above Discuss
- 6. If the slenderness ratio for a column is 100, then it is said to be a __________ column.
Options- A. long
- B. medium
- C. short Discuss
- 7. A concentrated load is one which
Options- A. acts at a point on a beam
- B. spreads non-uniformly over the whole length of a beam
- C. spreads uniformly over the whole length of a beam
- D. varies uniformly over the whole length of a beam Discuss
- 8. If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional to (where M = Bending moment)
Options- A. M
- B. M
- C. M2
- D. M3 Discuss
- 9. The object of caulking in a riveted joint is to make the joint
Options- A. free from corrosion
- B. stronger in tension
- C. free from stresses
- D. leak-proof Discuss
- 10. When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.
Options- A. single riveted
- B. double riveted Discuss
Strength of Materials problems
Search Results
Correct Answer: inversely proportional to
Correct Answer: energy stored in a body when strained within elastic limits
Correct Answer: bottom layer
Correct Answer: True
Correct Answer: none of the above
Correct Answer: long
Correct Answer: acts at a point on a beam
Correct Answer: M
Correct Answer: leak-proof
Correct Answer: double riveted
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.