Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
The limit of eccentricity is based upon no tension condition.
Options- A. True
- B. False
- Correct Answer
- True
- 1. When slack of an activity is negative
Options- A. it represents a situation where extra resources are available and the completion of project is not delayed
- B. it represents that a programme falls behind schedule and additional resources are required to complete the project in time
- C. the activity is critical and any delay in its performance will delay the completion of whole project
- D. all of the above Discuss
- 2. Linear programming model can be applied to line balancing problem and transportation problem.
Options- A. True
- B. False Discuss
- 3. PERT requires
Options- A. single time estimate
- B. double time estimate
- C. triple time estimate
- D. none of these Discuss
- 4. The probabilistic time is given by (where to = Optimistic time, tp = Pessimistic time, and tn = Most likely time)
Options- A.
- B.
- C.
- D.
Discuss
- 5. A-B-C analysis is used in
Options- A. CPM
- B. PERT
- C. inventory control
- D. all of these Discuss
- 6. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.
Options- A. distributed
- B. varying Discuss
- 7. The rectangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.
Options- A. same
- B. double
- C. four times
- D. six times Discuss
- 8. If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
Options- A. 0.20
- B. 0.30
- C. 0.50
- D. 0.60 Discuss
- 9. Resilience is the
Options- A. energy stored in a body when strained within elastic limits
- B. energy stored in a body when strained upto the breaking of the specimen
- C. maximum strain energy which can be stored in a body
- D. none of the above Discuss
- 10. In order to know whether a column is long or short, we must know its slenderness ratio.
Options- A. True
- B. False Discuss
Strength of Materials problems
Search Results
Correct Answer: it represents that a programme falls behind schedule and additional resources are required to complete the project in time
Correct Answer: True
Correct Answer: triple time estimate
Correct Answer:
Correct Answer: inventory control
Correct Answer: varying
Correct Answer: double
Correct Answer: 0.50
Correct Answer: none of the above
Correct Answer: True
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.