Discussion
Home ‣ Mechanical Engineering ‣ Industrial Engineering and Production Management Comments
- Question
In A-B-C analysis, which class of items are generally large in number?
Options- A. A
- B. B
- C. C
- D. none of these
- Correct Answer
- C
- 1. Bar chart is suitable for
Options- A. large project
- B. major work
- C. minor work
- D. all of these Discuss
- 2. Larger end cutting edge angle __________ tool life.
Options- A. increases
- B. decreases
- C. does not effect Discuss
- 3. A left hand tool on a lathe cuts most efficiently when it travels
Options- A. from left to right end of the lathe bed
- B. from right to left end of the lathe bed
- C. with the help of a compound slide
- D. across the bed Discuss
- 4. If the helix angle of the drill is made __________ 30°, then the torque required to drive the drill at a given feed will be more.
Options- A. equal to
- B. less than
- C. more than Discuss
- 5. Side rake angle on tools is provided to control chip flow.
Options- A. True
- B. False Discuss
- 6. In a line organisation
Options- A. responsibility of each individual is fixed
- B. discipline is strong
- C. quick decisions are taken
- D. all of these Discuss
- 7. Which of the following type of layout is suitable for automobile manufacturing concern?
Options- A. product layout
- B. process layout
- C. fixed position layout
- D. combination layout Discuss
- 8. Representative time is the average of times recorded by work study man for an operation.
Options- A. Agree
- B. Disagree Discuss
- 9. In order to avoid excessive multiplication of facilities, the layout preferred is
Options- A. product layout
- B. process layout
- C. group layout
- D. static layout Discuss
- 10. In time study, the rating factor is applied to determine
Options- A. standard time of a job
- B. merit rating of the worker
- C. fixation of incentive rate
- D. normal time of a worker Discuss
Industrial Engineering and Production Management problems
Search Results
Correct Answer: minor work
Correct Answer: decreases
Correct Answer: from left to right end of the lathe bed
Correct Answer: less than
Correct Answer: True
Correct Answer: all of these
Correct Answer: product layout
Correct Answer: Agree
Correct Answer: process layout
Correct Answer: normal time of a worker
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.