logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Production Engineering See What Others Are Saying!
  • Question

  • Which of the following statement is incorrect with reference of lathe cutting tools?


  • Options
  • A. The flank of the tool is the surface or surfaces below and adjacent to the cutting edges
  • B. The nose is the corner, arc or chamfer joining the side cutting and the end cutting edges
  • C. The heel is that part of the tool which is shaped to produce the cutting edges and face
  • D. The base is that surface of the shank which bears against the support and takes tangent pressure of the cut

  • Correct Answer
  • The heel is that part of the tool which is shaped to produce the cutting edges and face 

    • More questions

    • 1. The amount by which the outer edge of the rail is raised, is known as super-elevation.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 2. Process layout is also known as

    • Options
    • A. analyticallayout
    • B. synthetic layout
    • C. static product layout
    • D. none of these
      • Discuss
    • 3. There is no change in internal energy in an isothermal process.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 4. Combustuion of fuel takes place __________ the engine cylinder of a steam engine.

    • Options
    • A. outside
    • B. inside
      • Discuss
    • 5. The neutral axis of the cross-section a beam is that axis at which the bending stress is

    • Options
    • A. zero
    • B. minimum
    • C. maximum
    • D. infinity
      • Discuss
    • 6. The refrigerant used in small-tonnage commercial machines (hermetically sealed units) is

    • Options
    • A. ammonia
    • B. carbon dioxide
    • C. sulphur dioxide
    • D. R-12
      • Discuss
    • 7. A centrifugal compressor is an axial flow compressor.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 8. Second law of thermodynamics defines

    • Options
    • A. heat
    • B. work
    • C. internal energy
    • D. entropy
      • Discuss
    • 9. An open structure of a grinding wheel is denoted by the number 1 to 8.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 10. The ratio of total useful heat drop to the total isentropic heat drop, is called

    • Options
    • A. stage efficiency
    • B. internal efficiency
    • C. Rankine efficiency
    • D. none of these
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.