logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Production Engineering Comments

  • Question
  • The machining of titanium is difficult due to


  • Options
  • A. high thermal conductivity of titanium
  • B. chemical reaction between tool and work
  • C. low tool-chip contact area
  • D. none of these

  • Correct Answer
  • low tool-chip contact area 


  • Production Engineering problems


    Search Results


    • 1. The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is

    • Options
    • A. carbide, ceramic, cermet, borazon
    • B. ceramic, carbide, borazon, cermet
    • C. cermet, carbide, ceramic, borazon
    • D. borazon, ceramic, carbide, cermet
    • Discuss
    • 2. Side rake angle of a single point cutting tool is the angle

    • Options
    • A. by which the face of the tool is inclined towards back
    • B. by which the face of the tool is inclined sideways
    • C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
    • D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
    • Discuss
    • 3. The work or surface speed for cylindrical grinding varies from

    • Options
    • A. 5 to 10 m/min
    • B. 10 to 20 m/min
    • C. 20 to 30 m/min
    • D. 40 to 60 m/min
    • Discuss
    • 4. The lip angle of a single point tool is usually

    • Options
    • A. 20° to 40°
    • B. 40° to 60°
    • C. 60° to 80°
    • D. none of these
    • Discuss
    • 5. Drilling is an example of

    • Options
    • A. orthogonal cutting
    • B. oblique cutting
    • C. simple cutting
    • D. uniform cutting
    • Discuss
    • 6. The silicon carbide abrasive is chiefly used for grinding

    • Options
    • A. cemented carbide
    • B. ceramic
    • C. cast iron
    • D. all of these
    • Discuss
    • 7. A drill considered as a cutting tool having zero rake, is known as a

    • Options
    • A. flat drill
    • B. straight fluted drill
    • C. parallel shank twist drill
    • D. tapered shank twist drill
    • Discuss
    • 8. Segmental chips are formed during machining

    • Options
    • A. mild steel
    • B. cast iron
    • C. high speed steel
    • D. high carbon steel
    • Discuss
    • 9. The velocity of tool relative to the workpiece is known as cutting velocity.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. The average cutting speed for turning brass with a high speed steel tool is

    • Options
    • A. 15 to 19 m/min
    • B. 25 to 31 m/min
    • C. 60 to 90 m/min
    • D. 90 to 120 m/min
    • Discuss


    Comments

    There are no comments.

Enter a new Comment