logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Production Engineering Comments

  • Question
  • The work or surface speed for cylindrical grinding varies from


  • Options
  • A. 5 to 10 m/min
  • B. 10 to 20 m/min
  • C. 20 to 30 m/min
  • D. 40 to 60 m/min

  • Correct Answer
  • 20 to 30 m/min 


  • Production Engineering problems


    Search Results


    • 1. The lip angle of a single point tool is usually

    • Options
    • A. 20° to 40°
    • B. 40° to 60°
    • C. 60° to 80°
    • D. none of these
    • Discuss
    • 2. Drilling is an example of

    • Options
    • A. orthogonal cutting
    • B. oblique cutting
    • C. simple cutting
    • D. uniform cutting
    • Discuss
    • 3. The cutting tool in a milling machine is mounted on

    • Options
    • A. spindle
    • B. arbor
    • C. column
    • D. knee
    • Discuss
    • 4. The lead screw of a lathe has __________ threads.

    • Options
    • A. single start
    • B. double start
    • C. multi-start
    • D. any one of these
    • Discuss
    • 5. The tool made of cemented carbide wear out faster at

    • Options
    • A. slow speeds
    • B. medium speeds
    • C. fast speeds
    • D. very fast speeds
    • Discuss
    • 6. Side rake angle of a single point cutting tool is the angle

    • Options
    • A. by which the face of the tool is inclined towards back
    • B. by which the face of the tool is inclined sideways
    • C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
    • D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
    • Discuss
    • 7. The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is

    • Options
    • A. carbide, ceramic, cermet, borazon
    • B. ceramic, carbide, borazon, cermet
    • C. cermet, carbide, ceramic, borazon
    • D. borazon, ceramic, carbide, cermet
    • Discuss
    • 8. The machining of titanium is difficult due to

    • Options
    • A. high thermal conductivity of titanium
    • B. chemical reaction between tool and work
    • C. low tool-chip contact area
    • D. none of these
    • Discuss
    • 9. The silicon carbide abrasive is chiefly used for grinding

    • Options
    • A. cemented carbide
    • B. ceramic
    • C. cast iron
    • D. all of these
    • Discuss
    • 10. A drill considered as a cutting tool having zero rake, is known as a

    • Options
    • A. flat drill
    • B. straight fluted drill
    • C. parallel shank twist drill
    • D. tapered shank twist drill
    • Discuss


    Comments

    There are no comments.

Enter a new Comment