logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Heat Transfer, Refrigeration and Air Conditioning Comments

  • Question
  • The condition of refrigerant after leaving the compressor and before entering the condenser is superheated vapour.


  • Options
  • A. Yes
  • B. No

  • Correct Answer
  • Yes 


  • Heat Transfer, Refrigeration and Air Conditioning problems


    Search Results


    • 1. Which of the following represents a heat pump?

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. In case of solids, the heat transfer takes place according to radiation.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 3. The humidity ratio or specific humidity is the mass of water vapour present in

    • Options
    • A. 1 m3 of wet air
    • B. 1 m3 of dry air
    • C. 1 kg of wet air
    • D. 1 kg of dry air
    • Discuss
    • 4. In free convection heat transfer transition from laminar to turbulent flow is governed by the critical value of the

    • Options
    • A. Reynold's number
    • B. Grashoff's number
    • C. Reynold's number, Grashoff's number
    • D. Prandtl number, Grashoff's number
    • Discuss
    • 5. The critical radius is the insulation radius at which the resistance to heat flow is

    • Options
    • A. maximum
    • B. minimum
    • C. zero
    • D. none of these
    • Discuss
    • 6. The heat transfer takes place according to

    • Options
    • A. Zeroth law of thermodynamics
    • B. First law of thermodynamics
    • C. Second law of thermodynamics
    • D. Kirchhoff's law
    • Discuss
    • 7. The amount of radiation mainly depends upon the

    • Options
    • A. nature of the body
    • B. temperature of the body
    • C. type of surface of the body
    • D. all of these
    • Discuss
    • 8. The temperature of ammonia after compression in a vapour compression system is

    • Options
    • A. 20 to 50° C
    • B. 50 to 70° C
    • C. 70 to 110° C
    • D. none of these
    • Discuss
    • 9. The coefficient of performance of Heat Pump is always __________ one.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • Discuss
    • 10. Degree of saturation or percentage humidity is

    • Options
    • A. the mass of water vapour present in 1 m3 of dry air
    • B. the mass of water vapour present in 1 kg of dry air
    • C. the ratio of the actual mass of water vapour in a unit mass of dry air to the mass of water vapour in the same mass of dry air when it is saturated at the same temperature and pressure.
    • D. the ratio of actual mass of water vapour in a given volume of moist air to the mass of water vapour in the same volume of saturated air at the same temperature and pressure
    • Discuss


    Comments

    There are no comments.

Enter a new Comment