logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Heat Transfer, Refrigeration and Air Conditioning See What Others Are Saying!
  • Question
  • The wet bulb temperature during sensible heating of air


  • Options
  • A. remains constant
  • B. increases
  • C. decreases

  • Correct Answer
  • increases 


  • More questions

    • 1. The rigid suspension is beneficial when

    • Options
    • A. it is desired to reduce the unsprung mass
    • B. it is desired to have more flexibility in design
    • C. it is desired to improve tyre-to-ground contact characteristics
    • D. large changes in load make it necessary to have a large suspension stroke
    • Discuss
    • 2. The heat absorbed during a polytropic process is

    • Options
    • A. x Workdone
    • B.
    • C.
    • D. all of these
    • Discuss
    • 3. The relative humidity decreases as air gets wet.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. Scab is a casting defect which occurs as sand patches on the upper surface of a casting.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. When the discharge pressure is too high in a refrigeration system, high pressure control is installed to stop the compressor.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 6. Small nose radius

    • Options
    • A. increases tool life
    • B. decreases tool life
    • C. produces chipping and decreases tool life
    • D. results in excessive stress concentration and greater heat generation
    • Discuss
    • 7. The component that connects the steering rack to the knuckles is

    • Options
    • A. tie-rod
    • B. sector gear
    • C. pivot
    • D. spline
    • Discuss
    • 8. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

    • Options
    • A. distributed
    • B. varying
    • Discuss
    • 9. Thermal equilibrium means that the flow of steam is

    • Options
    • A. isothermal
    • B. isentropic
    • C. hyperbolic
    • D. polytropic
    • Discuss
    • 10. Silicon when added to copper improves

    • Options
    • A. machinability
    • B. hardness
    • C. hardness and strength
    • D. strength and ductility
    • Discuss


    Comments

    There are no comments.

Enter a new Comment