Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
The pressure at the end of compression, in diesel engines, is approximately
Options- A. 10 bar
- B. 20 bar
- C. 25 bar
- D. 35 bar
- Correct Answer
- 35 bar
- 1. The ratio of the volume of charge admitted at N.T.P. to the swept volume of the piston is called
Options- A. mechanical efficiency
- B. overall efficiency
- C. volumetric efficiency
- D. relative efficiency Discuss
- 2. In hit and miss governing, the fuel supply is cut-off completely during one or more number of cycles.
Options- A. Yes
- B. No Discuss
- 3. In petrol engine, using a fixed octane rating fuel and fixed compression ratio, supercharging will __________ the knocking tendency.
Options- A. not effect
- B. decrease
- C. increase Discuss
- 4. A moderator, in nuclear power plants, is a medium introduced into the fuel mass in order to
Options- A. slow down the speed of fast moving neutrons
- B. control the reaction
- C. reduce the temperature
- D. extract heat from nuclear reaction Discuss
- 5. The pre-ignition occurs before the spark is produced whereas detonation develops after the introduction of spark.
Options- A. Agree
- B. Disagree Discuss
- 6. The energy released during the fission of one atom of Uranium - 235 in million electron volts is about
Options- A. 100
- B. 200
- C. 300
- D. 400 Discuss
- 7. In a four stroke cycle petrol engine, the charge is ignited at
Options- A. 30° before top dead centre
- B. 30° after top dead centre
- C. 30° before bottom dead centre
- D. 30° after bottom dead centre Discuss
- 8. The predominent isotope of the naturally occuring element is
Options- A. U235
- B. U238
- C. Pu233
- D. Pu239 Discuss
- 9. In a four stroke cycle, the minimum temperature inside the engine cylinder occurs at the
Options- A. beginning of suction stroke
- B. end of suction stroke
- C. beginning of exhaust stroke
- D. end of exhaust stroke Discuss
- 10. High speed compression engines operate on
Options- A. Otto cycle
- B. Diesel cycle
- C. Dual-combustion cycle
- D. all of these Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: volumetric efficiency
Correct Answer: Yes
Correct Answer: increase
Correct Answer: slow down the speed of fast moving neutrons
Correct Answer: Agree
Correct Answer: 200
Correct Answer: 30° before top dead centre
Correct Answer: U238
Correct Answer: beginning of suction stroke
Correct Answer: Dual-combustion cycle
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.