Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
The effective inhibitor of pre-ignition is
Options- A. alcohol
- B. water
- C. lead
- D. none of these
- Correct Answer
- water
- 1. The expansion of fuel in a four stroke cycle diesel engine
Options- A. starts at 15° before top dead centre and ends at 30° after top dead centre
- B. starts at top dead centre and ends at 30° after top dead centre
- C. starts at 15° after top dead centre and ends at 30° before bottom dead centre
- D. may start and end anywhere Discuss
- 2. The exhaust valve in a four stroke cycle petrol engine
Options- A. opens at 50° before bottom dead centre and closes at 15° after top dead centre
- B. opens at bottom dead centre and closes at top dead centre
- C. opens at 50° after bottom dead centre and closes at 15° before top dead centre
- D. may open and close anywhere Discuss
- 3. The self ignition temperature of petrol is __________ as compared to diesel oil.
Options- A. same
- B. lower
- C. higher Discuss
- 4. The diesel engines are also known as __________ engines.
Options- A. compression ignition
- B. spark ignition Discuss
- 5. Nuclear reactors are used
Options- A. to produce heat for thermoelectric power
- B. to produce fissionable material
- C. to propel ships, submarines, aircrafts
- D. all of these Discuss
- 6. The pre-ignition occurs before the spark is produced whereas detonation develops after the introduction of spark.
Options- A. Agree
- B. Disagree Discuss
- 7. A moderator, in nuclear power plants, is a medium introduced into the fuel mass in order to
Options- A. slow down the speed of fast moving neutrons
- B. control the reaction
- C. reduce the temperature
- D. extract heat from nuclear reaction Discuss
- 8. In petrol engine, using a fixed octane rating fuel and fixed compression ratio, supercharging will __________ the knocking tendency.
Options- A. not effect
- B. decrease
- C. increase Discuss
- 9. In hit and miss governing, the fuel supply is cut-off completely during one or more number of cycles.
Options- A. Yes
- B. No Discuss
- 10. The ratio of the volume of charge admitted at N.T.P. to the swept volume of the piston is called
Options- A. mechanical efficiency
- B. overall efficiency
- C. volumetric efficiency
- D. relative efficiency Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: starts at 15° after top dead centre and ends at 30° before bottom dead centre
Correct Answer: opens at 50° before bottom dead centre and closes at 15° after top dead centre
Correct Answer: higher
Correct Answer: compression ignition
Correct Answer: all of these
Correct Answer: Agree
Correct Answer: slow down the speed of fast moving neutrons
Correct Answer: increase
Correct Answer: Yes
Correct Answer: volumetric efficiency
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.