Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
The self ignition temperature of petrol is __________ as compared to diesel oil.
Options- A. same
- B. lower
- C. higher
- Correct Answer
- higher
- 1. The diesel engines are also known as __________ engines.
Options- A. compression ignition
- B. spark ignition Discuss
- 2. Nuclear reactors are used
Options- A. to produce heat for thermoelectric power
- B. to produce fissionable material
- C. to propel ships, submarines, aircrafts
- D. all of these Discuss
- 3. In open combustion chamber in diesel engines, the shape and layout of the piston crown, the inlet port and the valve produce the turbulent effect of fuel mixture.
Options- A. True
- B. False Discuss
- 4. The pressure inside the cylinder is __________ the atmospheric pressure during the exhaust stroke.
Options- A. equal to
- B. below
- C. above Discuss
- 5. A diesel engine has
Options- A. one valve
- B. two valves
- C. three valves
- D. four valves Discuss
- 6. The exhaust valve in a four stroke cycle petrol engine
Options- A. opens at 50° before bottom dead centre and closes at 15° after top dead centre
- B. opens at bottom dead centre and closes at top dead centre
- C. opens at 50° after bottom dead centre and closes at 15° before top dead centre
- D. may open and close anywhere Discuss
- 7. The expansion of fuel in a four stroke cycle diesel engine
Options- A. starts at 15° before top dead centre and ends at 30° after top dead centre
- B. starts at top dead centre and ends at 30° after top dead centre
- C. starts at 15° after top dead centre and ends at 30° before bottom dead centre
- D. may start and end anywhere Discuss
- 8. The effective inhibitor of pre-ignition is
Options- A. alcohol
- B. water
- C. lead
- D. none of these Discuss
- 9. The pre-ignition occurs before the spark is produced whereas detonation develops after the introduction of spark.
Options- A. Agree
- B. Disagree Discuss
- 10. A moderator, in nuclear power plants, is a medium introduced into the fuel mass in order to
Options- A. slow down the speed of fast moving neutrons
- B. control the reaction
- C. reduce the temperature
- D. extract heat from nuclear reaction Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: compression ignition
Correct Answer: all of these
Correct Answer: True
Correct Answer: above
Correct Answer: three valves
Correct Answer: opens at 50° before bottom dead centre and closes at 15° after top dead centre
Correct Answer: starts at 15° after top dead centre and ends at 30° before bottom dead centre
Correct Answer: water
Correct Answer: Agree
Correct Answer: slow down the speed of fast moving neutrons
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.