Discussion
Home ‣ Mechanical Engineering ‣ Steam Nozzles and Turbines Comments
- Question
A nozzle is said to be a convergent nozzle
Options- A. when the cross-section of the nozzle increases continuously from entrance to exit
- B. when the cross-section of the nozzle decreases continuously from entrance to exit
- C. when the cross-section of the nozzle first decreases from entrance to throat and then increases from its throat to exit
- D. none of the above
- Correct Answer
- when the cross-section of the nozzle decreases continuously from entrance to exit
- 1. When the back pressure of a nozzle is below the designed value of pressure at exit of nozzle, the nozzle is said to be
Options- A. choked
- B. underdamping
- C. overdamping
- D. none of these Discuss
- 2. The rate of discharge through the nozzle __________ when the exit pressure is gradually reduced.
Options- A. remains same
- B. decreases
- C. increases Discuss
- 3. In a convergent divergent nozzle, the discharge depends upon the initial conditions of steam and the area of nozzle at throat.
Options- A. Correct
- B. Incorrect Discuss
- 4. Parson's turbine is a
Options- A. simple impulse turbine
- B. simple reaction turbine
- C. impulse-reaction turbine
- D. none of these Discuss
- 5. The steam leaves the nozzle at a
Options- A. high pressure and a low velocity
- B. high pressure and a high velocity
- C. low pressure and a low velocity
- D. low pressure and a high velocity Discuss
- 6. The critical pressure ratio for initially dry saturated steam is more as compared to initially wet steam.
Options- A. Yes
- B. No Discuss
- 7. The purpose of testing an internal combustion engine is
Options- A. to determine the information, which can not be obtained by calculations
- B. to conform the data used in design, the validity of which may be doubtful
- C. to satisfy the customer regarding the performance of the engine
- D. all of the above Discuss
- 8. The thermal efficiency of a standard Otto cycle for a compression ratio of 5.5 will be
Options- A. 25%
- B. 50%
- C. 70%
- D. 100% Discuss
- 9. Where reactor operation is designed with fast neutrons such as in reactors using highly enriched fuel, the moderator used is
Options- A. heavy water
- B. graphite
- C. carbon dioxide
- D. no moderator is needed Discuss
- 10. The compensating jet in a carburettor supplies almost constant amount of petrol at all speeds because the
Options- A. jet area is automatically varied depending on the suction
- B. the flow from the main jet is diverted to the compensating jet with increase in speed
- C. the diameter of the jet is constant and the discharge coefficient is invariant
- D. flow is produced due to the static head in the float chamber Discuss
Steam Nozzles and Turbines problems
Search Results
Correct Answer: underdamping
Correct Answer: increases
Correct Answer: Correct
Correct Answer: simple reaction turbine
Correct Answer: low pressure and a high velocity
Correct Answer: No
Correct Answer: all of the above
Correct Answer: 50%
Correct Answer: no moderator is needed
Correct Answer: flow is produced due to the static head in the float chamber
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.