Discussion
Home ‣ Computer Science ‣ Electronic Principles Comments
- Question
Which one of the following statements is true for voltage in a parallel circuit?
Options- A. The total voltage in a parallel circuit is equal to the average value of the individual voltages
- B. The total voltage in a parallel circuit is always less than the value of the smallest voltage
- C. The total voltage is equal to the sum of the voltages across the individual branches in a parallel circuit
- D. The total voltage of a parallel circuit is the same as the voltages across each branch
- E. None of the above
- Correct Answer
- The total voltage of a parallel circuit is the same as the voltages across each branch
- 1. Doubling the operating frequency of a purely inductive circuit:
Options- A. doubles the amount of current through the inductors
- B. has no effect on the current through the inductors
- C. cuts the current through the inductors one-half
- D. increases the current, but by an amount that can be determined only by doing a complete analysis of the circuit
- E. None of the above Discuss
- 2. 1 Microfarad is the same as:
Options- A. 1 millionth of a picofarad
- B. 1000 millifarads
- C. 1 million picofarads
- D. 1 million farads
- E. None of the above Discuss
- 3. When operating below its resonant frequency, a series RLC circuit has the characteristics of a:
Options- A. series RL circuit
- B. series RC circuit
- C. series RLC circuit operated above its resonant frequency
- D. purely resistive circuit
- E. None of the above Discuss
- 4. A transistor has how many doped regions?
Options- A. 1
- B. 2
- C. 3
- D. 4
- E. None of the above Discuss
- 5. The voltage across a 1N4001 is 0.93V when the current is 1A. What is the power dissipation of the diode for these values?
Options- A. 0.93 W
- B. 0.93 V
- C. 1 A
- D. 9.3 W
- E. None of the above Discuss
- 6. What are the main parts of an atom?
Options- A. Protons only
- B. Electrons, protons, and ions
- C. Electrons, ions, and neutrons
- D. Electrons, protons, and neutrons
- E. None of the above Discuss
- 7. Inductive reactance is measured in units of:
Options- A. volts per second
- B. amperes per second
- C. Ohm
- D. henrys
- E. None of the above Discuss
- 8. A real voltage source has
Options- A. Zero internal resistance
- B. Infinite internal resistance
- C. A small internal resistance
- D. A large internal resistance
- E. None of the above Discuss
- 9. The barrier potential accross each depletion layer is
Options- A. 0
- B. 0.8 V
- C. 0.7 V
- D. 20 V
- E. None of the above Discuss
- 10. At cut off, the Q point is at
Options- A. upper end of the load line
- B. middle of the load line
- C. lower end of the load line
- D. infinity
- E. None of the above Discuss
Electronic Principles problems
Search Results
Correct Answer: cuts the current through the inductors one-half
Correct Answer: 1 million picofarads
Correct Answer: series RC circuit
Correct Answer: 3
Correct Answer: 0.93 W
Correct Answer: Electrons, protons, and neutrons
Correct Answer: Ohm
Correct Answer: A small internal resistance
Correct Answer: 0.7 V
Correct Answer: lower end of the load line
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.