logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Electronic Principles Comments

  • Question
  • Assuming 100% efficiency, what is the power being consumed at the secondary winding of the transformer described in question 91?


  • Options
  • A. 200 W
  • B. 1000 W
  • C. 20 W
  • D. 100 W
  • E. None of the above

  • Correct Answer
  • 200 W 


  • Electronic Principles problems


    Search Results


    • 1. Which one of the following phrasers best describes flux density?

    • Options
    • A. The concentration of lines of magnetic force
    • B. The rate of change of the number of lines of magnetic force
    • C. The opposition to a build-up of magnetic fields
    • D. The force that maintains lines of force
    • E. None of the above
    • Discuss
    • 2. To get the Thevenin voltage, you have to

    • Options
    • A. Short the load resistor
    • B. Open the load resister
    • C. Short the voltage source
    • D. Open the voltage source
    • E. None of the above
    • Discuss
    • 3. What is the difference between a conductor and an insulator?

    • Options
    • A. A conductor allows current to flow much easier than an insulator does
    • B. An insulator has an excessive number of free electrons, while a conductor has a few free electrons or none at all
    • C. An insulator allows current to flow much easier than a conductor does
    • D. The difference between conductors and insulators depends on how they are used
    • E. None of the above
    • Discuss
    • 4. The total capacitance of a series capacitor circuit is:

    • Options
    • A. equal to the sun of the individual capacitive-reactance values
    • B. equal to the sum of the individual capacitance values
    • C. equal to the source voltage divided by total current
    • D. less than the value of the smallest capacitor
    • E. None of the above
    • Discuss
    • 5. Assuming 100% efficiency, what is the power being applied to the primary winding of the transformer described in the above question?

    • Options
    • A. 200 W
    • B. 1000 W
    • C. 20 W
    • D. 100 W
    • E. None of the above
    • Discuss
    • 6. A zener diode has a voltage of 10 V and a current of 20 mA. What is the power dissipation?

    • Options
    • A. 200 mW
    • B. 300 mW
    • C. 20 mW
    • D. 10 mW
    • E. None of the above
    • Discuss
    • 7. Which one of the following is a statement of KirchhofFs voltage law?

    • Options
    • A. The total voltage in a parallel circuit is less than the value of the smallest voltage
    • B. The algebraic sum of voltages in a loop is equal to zero
    • C. The voltage drop across a resistance is proportional to the value of resistance and the amount of current flowing through it
    • D. The algebraic sum of voltages entering and leaving a point is equal to zero
    • E. None of the above
    • Discuss
    • 8. Which one of the following statements is true for the impedance of a series RC circuit?

    • Options
    • A. The impedance is greater than the sum of the resistance and capacitive reactance
    • B. The impedance is equal to the sum of the resistance and capacitive reactance
    • C. The impedance is greater than either the resistance or capacitive reactance but less than their sum
    • D. The impedance is less than the sum of the resistance and capacitive reactance
    • E. None of the above
    • Discuss
    • 9. At room temperature an intrinsic semiconductor has

    • Options
    • A. a few free electrons and holes
    • B. many holes
    • C. many free electrons
    • D. No holes
    • E. None of the above
    • Discuss
    • 10. An audio transformer has a turn ratio of 9, What is its impedance ratio?

    • Options
    • A. 81
    • B. 85
    • C. 6
    • D. 9
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment