CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Computer Science
‣
Electronic Principles
Comments
Question
Current and voltage are said to be in phase when:
Options
A. their waveforms are both ac or both dc
B. they have the same amplitude and frequency
C. their waveforms cross through zero and reach positive and negative peaks at the same time
D. All of the above
E. None of the above
Correct Answer
their waveforms cross through zero and reach positive and negative peaks at the same time
Electronic Principles problems
Search Results
1. When a parallel RLC circuit is operating at its resonant frequency:
Options
A. capacitive reactance is greater than the inductive reactance
B. inductive reactance is greater than the capacitive reactance
C. inductive reactance is equal to the capacitive reactance
D. the difference between inductive and capacitive reactance is equal to the resistance
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: inductive reactance is equal to the capacitive reactance
2. What is the impedance of a circuit composed of a 100 ohm resistor connected in parallel with an inductor that has a reactance of 200 W?
Options
A. 77.7 ohm
B. 89.3 ohm
C. 88.8 ohm
D. 224 ohm
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 89.3 ohm
3. Which one of. the following phrases most accurately describes the nature of a pulsating dc voltage?
Options
A. The voltage remains at one polarity and at a steady level
B. The voltage remains at one polarity but changes value periodically
C. The voltage causes current to flow in two directions at the same time
D. The voltage reverses polarity periodically
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: The voltage remains at one polarity but changes value periodically
4. The transistor has a collector current of 2 mA. If the current gain is 135, what is the base current?
Options
A. 14.8 ľA
B. 10.3 ľA
C. 7.8 ľA
D. 7.75 ľA
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 14.8 ľA
5. A basic capacitor is composed of:
Options
A. two conductors separated by a dielectric
B. two dielectrics separated by a conductor
C. two coils separated by a dielectric
D. two coils separated by a conductor
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: two conductors separated by a dielectric
6. The Thevenin resistance is equal in value to the
Options
A. Load resistance
B. Half the load resistance
C. Internal resistance of a Morton circuit
D. Open-load resistance
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: Load resistance
7. Which one of the following statements is true for the currents in a parallel RL circuit?
Options
A. The total current is equal to the sum of the currents through the resistance and inductance
B. The current always has the same amplitude and phase for every part of the circuit
C. The total current is less than the sum of the currents through the resistance and inductance
D. The total current leads the total voltage by less than 90
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: The total current is less than the sum of the currents through the resistance and inductance
8. For normal operation of the transistor, the collector diode has to be
Options
A. Forward-biased
B. Reverse-biased
C. Nonconducting
D. Operating in the breakdown region
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: Reverse-biased
9. The primary impedance of a transformer is 60 ohm and the secondary impedance is 120 ohm. What is the impedance ratio?
Options
A. 0.25
B. 180
C. 0.5
D. 4
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 0.5
10. Most AC power is obtained from:
Options
A. generators
B. batteries
C. oscillators
D. lightning
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: oscillators
Comments
There are no comments.
Enter a new Comment
Save
More in Computer Science:
Artificial Intelligence
Automation System
Computer Fundamentals
Computer Hardware
Database Systems
Digital Computer Electronics
Disk Operating System (DOS)
Electronic Principles
Language Processors
Linux
Management Information Systems
Networking
Object Oriented Programming Using C++
Operating Systems Concepts
System Analysis and Design
Unix
Windows 2000 Server
Windows NT