Discussion
Home ‣ Computer Science ‣ Electronic Principles Comments
- Question
Which one of the following statements is true for the voltage in a parallel RC circuit?
Options- A. The voltage always has the same amplitude and phase for every part of the circuit
- B. The total voltage is equal to the sum of the voltages across the resistance and capacitance
- C. The total voltage leads the total current by less than 90 degree
- D. The total voltage is less than the sum of the voltages across the resistance and capacitance
- E. None of the above
- Correct Answer
- The voltage always has the same amplitude and phase for every part of the circuit
- 1. The graph of current gain versus collector current indicates that the current gain
Options- A. varies enormously
- B. is contant
- C. varies slightly
- D. equals the collector current divided by the base current
- E. None of the above Discuss
- 2. The basic unit of measurement for current is the:
Options- A. volt
- B. watt
- C. ampere
- D. ohm
- E. None of the above Discuss
- 3. In a step-down transformer, which is larger?
Options- A. Primary voltage
- B. Secondary voltage
- C. Neither
- D. Impossible to say
- E. None of the above Discuss
- 4. In a transistor operates at the middle of the load line, an increase in the base resistance will move the Q point
Options- A. down
- B. up
- C. nowhere
- D. off the load line
- E. None of the above Discuss
- 5. The Norton current is sometimes called the
Options- A. Shorted-load current
- B. Open-load current
- C. Thevenin current
- D. Thevenin voltage
- E. None of the above Discuss
- 6. The total impedance of a series RLC circuit:
Options- A. is minimum at the resonant frequency
- B. always increases as the applied frequency increases
- C. always decreases as the applied frequency increases
- D. is maximum at the resonant frequency
- E. None of the above Discuss
- 7. The equivalent of 1 megohms is:
Options- A. 1 k ohm
- B. 100,000 ohm
- C. one-millionth of an ohm
- D. one million ohms
- E. None of the above Discuss
- 8. Suppose a current source has an Ideal current of 10 mA and an internal resistance of 20 MW. For what values of load resistance will the current source appear stiff?
Options- A. 20 k Ohm or more
- B. 200 k Ohm or less
- C. 200 k Ohm or more
- D. 20 km or less
- E. None of the above Discuss
- 9. A diode is in series with 220W. If the voltage across the resister is 4V, what is the current through the diode?
Options- A. 55 A
- B. 55.86 A
- C. 18.2 mA
- D. 16.3 mA
- E. None of the above Discuss
- 10. The merging of a free electron and a hole is called
Options- A. Covalent bonding
- B. Lifetime
- C. Recombination
- D. Thermal energy
- E. None of the above Discuss
Electronic Principles problems
Search Results
Correct Answer: equals the collector current divided by the base current
Correct Answer: ampere
Correct Answer: Primary voltage
Correct Answer: down
Correct Answer: Shorted-load current
Correct Answer: is minimum at the resonant frequency
Correct Answer: one million ohms
Correct Answer: 200 k Ohm or less
Correct Answer: 18.2 mA
Correct Answer: Recombination
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.