logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Automation System Comments

  • Question
  • A smart solid-state sensor is:


  • Options
  • A. one that integrates both logic and a solid-state sensor into one unit.
  • B. one that has two or three substrates
  • C. not available today
  • D. All of the above
  • E. None of the above

  • Correct Answer
  • one that integrates both logic and a solid-state sensor into one unit. 


  • Automation System problems


    Search Results


    • 1. An operating system:

    • Options
    • A. is required to run a microprocessor system
    • B. provides a structure with which to develop application programs
    • C. is useful because standard modules can be used
    • D. both (b) and (c)
    • E. None of the above.
    • Discuss
    • 2. Skipping every other line and picking up the skipped lines on the second pass is called:

    • Options
    • A. interlacing
    • B. refresh-vector
    • C. raster-scan
    • D. stroke writing
    • E. None of the above
    • Discuss
    • 3. The program execution time:

    • Options
    • A. must be slower than the fastest mechanical operation that is to be controlled
    • B. will vary depending on the language used
    • C. cannot be changed once the program is written
    • D. All of the above
    • E. None of the above
    • Discuss
    • 4. One advantage of a PC in industrial control is that it:

    • Options
    • A. has a reliable long life compared to relay logic
    • B. is very difficult for the inexperienced programmer to understand
    • C. is unreliable because there are no moving parts
    • D. All of the above
    • E. None of the above
    • Discuss
    • 5. In the operation of a programmable controller:

    • Options
    • A. all of the logic status is maintained in memory
    • B. any latched data must be done using an external latching relay
    • C. mathematics cannot be performed
    • D. All of the above
    • E. None of the above
    • Discuss
    • 6. The general CAD system was development by considering a wide range of possible uses of such a system.

    • Options
    • A. Mechanical engineering design
    • B. Animation and graphic design
    • C. Structural engineering design and Electronic circuit design
    • D. All of the above
    • E. None of the above
    • Discuss
    • 7. Having compatibility and commonality in and between vendors' equipment is called:

    • Options
    • A. registration
    • B. standardization
    • C. integration
    • D. networking
    • E. None of the above
    • Discuss
    • 8. An up/down counter used in a TI510PC has three inputs. Which of the following is not one of them?

    • Options
    • A. Count up
    • B. Count out
    • C. Reset.
    • D. Count down
    • E. None of the above
    • Discuss
    • 9. The "end-effector" of a robot:

    • Options
    • A. can be an actual tool
    • B. is the robot "hand"
    • C. may have a gripping action
    • D. All of the above
    • E. None of the above
    • Discuss
    • 10. Which of the following are kinds of instructions?

    • Options
    • A. Input
    • B. Arithmetic
    • C. Conditional branching
    • D. All of the above
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment