logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Automation System Comments

  • Question
  • A set of well-defined procedures based on mathematical and geometric formulas for solving a problem in a finite number of steps is called:


  • Options
  • A. a permutation
  • B. an algorithm
  • C. arithmetic logic
  • D. a geometric model
  • E. None of the above

  • Correct Answer
  • an algorithm 


  • Automation System problems


    Search Results


    • 1. Which of the methods below can be used to tell a robot what it is to do?

    • Options
    • A. Walk-through
    • B. Set mechanical stops
    • C. Software program
    • D. (a) and (c)
    • E. None of the above
    • Discuss
    • 2. For a type 2 system, the steady-state:

    • Options
    • A. error for a step input is always zero
    • B. error for a velocity input is always zero
    • C. input for acceleration input is always non-zero
    • D. All of the above
    • E. None of the above
    • Discuss
    • 3. The refresh-vector CRT uses which of the following techniques?

    • Options
    • A. The beam constantly travels across the screen to turn on/off a series of pixels.
    • B. Makes changes on the image by increasing the anode voltage.
    • C. Uses an electron gun to continuously flood the surface of the tube.
    • D. Creates images on the screen by scanning straight-line vectors between selected points.
    • E. None of the above
    • Discuss
    • 4. A stepping motor;

    • Options
    • A. has a speed proportional to voltage input
    • B. has a commutator
    • C. is a good choice where continuous rotation is needed
    • D. can index positional movement.
    • E. None of the above
    • Discuss
    • 5. VLSI (very large scale integrated circuits) logic:

    • Options
    • A. will not be available in this decade
    • B. means more costly electronic products in the future
    • C. will result in lower cost, higher capability electronic equipment
    • D. All of the above
    • E. None of the above
    • Discuss
    • 6. The speed at which the monitor accepts data is called:

    • Options
    • A. bandwidth
    • B. response time
    • C. interlacing
    • D. scanning
    • E. None of the above
    • Discuss
    • 7. A microprocessor:

    • Options
    • A. is another name for a computer
    • B. is a CPU in integrated circuit form
    • C. executes a program of instructions
    • D. (a) and (c)
    • E. None of the above
    • Discuss
    • 8. Microcomputer-based control sys¬tems

    • Options
    • A. will just keep their present capability
    • B. will have more standard industrial application software available in the future.
    • C. will tend to increase in cost.
    • D. All of the above
    • E. None of the above
    • Discuss
    • 9. For a type 1 system, the steady-state:

    • Options
    • A. error for a step input is always zero
    • B. error for a velocity input is always zero
    • C. input for acceleration input is always non-zero
    • D. (a) and (c)
    • E. None of the above
    • Discuss
    • 10. Who are called steel collar workers?

    • Options
    • A. Office clerks
    • B. Factory workers
    • C. Steel factory workers
    • D. Robots
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment