Discussion
Home ‣ Computer Science ‣ Automation System Comments
- Question
Which of the methods below can be used to tell a robot what it is to do?
Options- A. Walk-through
- B. Set mechanical stops
- C. Software program
- D. (a) and (c)
- E. None of the above
- Correct Answer
- (a) and (c)
- 1. For a type 2 system, the steady-state:
Options- A. error for a step input is always zero
- B. error for a velocity input is always zero
- C. input for acceleration input is always non-zero
- D. All of the above
- E. None of the above Discuss
- 2. The refresh-vector CRT uses which of the following techniques?
Options- A. The beam constantly travels across the screen to turn on/off a series of pixels.
- B. Makes changes on the image by increasing the anode voltage.
- C. Uses an electron gun to continuously flood the surface of the tube.
- D. Creates images on the screen by scanning straight-line vectors between selected points.
- E. None of the above Discuss
- 3. A stepping motor;
Options- A. has a speed proportional to voltage input
- B. has a commutator
- C. is a good choice where continuous rotation is needed
- D. can index positional movement.
- E. None of the above Discuss
- 4. VLSI (very large scale integrated circuits) logic:
Options- A. will not be available in this decade
- B. means more costly electronic products in the future
- C. will result in lower cost, higher capability electronic equipment
- D. All of the above
- E. None of the above Discuss
- 5. An assembly language instruction:
Options- A. is written in ones and zeros
- B. corresponds to one computer operation
- C. does not require knowledge of the computer design
- D. All of the above
- E. None of the above Discuss
- 6. A set of well-defined procedures based on mathematical and geometric formulas for solving a problem in a finite number of steps is called:
Options- A. a permutation
- B. an algorithm
- C. arithmetic logic
- D. a geometric model
- E. None of the above Discuss
- 7. The speed at which the monitor accepts data is called:
Options- A. bandwidth
- B. response time
- C. interlacing
- D. scanning
- E. None of the above Discuss
- 8. A microprocessor:
Options- A. is another name for a computer
- B. is a CPU in integrated circuit form
- C. executes a program of instructions
- D. (a) and (c)
- E. None of the above Discuss
- 9. Microcomputer-based control sys¬tems
Options- A. will just keep their present capability
- B. will have more standard industrial application software available in the future.
- C. will tend to increase in cost.
- D. All of the above
- E. None of the above Discuss
- 10. For a type 1 system, the steady-state:
Options- A. error for a step input is always zero
- B. error for a velocity input is always zero
- C. input for acceleration input is always non-zero
- D. (a) and (c)
- E. None of the above Discuss
Automation System problems
Search Results
Correct Answer: All of the above
Correct Answer: Creates images on the screen by scanning straight-line vectors between selected points.
Correct Answer: can index positional movement.
Correct Answer: will result in lower cost, higher capability electronic equipment
Correct Answer: corresponds to one computer operation
Correct Answer: an algorithm
Correct Answer: bandwidth
Correct Answer: (a) and (c)
Correct Answer: will have more standard industrial application software available in the future.
Correct Answer: (a) and (c)
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.