Discussion
Home ‣ Computer Science ‣ Automation System Comments
- Question
Which of the following devices could be part of a sensor?
Options- A. thermometer
- B. brake
- C. relay
- D. clutch.
- E. None of the above
- Correct Answer
- thermometer
- 1. A semi-continuous operation means:
Options- A. the operation is continuous each shift, but stops between shifts
- B. coffee breaks are allowed for the operator
- C. a computer is a required part of the machine
- D. each operation in a sequence is continuous, but subsequent operations in the sequence may be different.
- E. None of the above Discuss
- 2. The device that assembles groups of characters into complete messages prior to their entering the CPU is called:
Options- A. a compiler
- B. an interpreter
- C. a communications processor
- D. an editor
- E. None of the above Discuss
- 3. A solenoid:
Options- A. can be used only in de circuits
- B. is spring operated
- C. is widely used in industrial automation
- D. is related to an aneroid
- E. None of the above Discuss
- 4. If the transient response of a system is overdamped:
Options- A. the value of the output exceeds the value of the input at times during the transient period.
- B. the value of the output never exceeds the value of the input during the transient period.
- C. the value of the output never stabilizes.
- D. All of the above
- E. None of the above Discuss
- 5. A disadvantage of Numerical Control (NC) is:
Options- A. the computer is not reliable
- B. the tape and tape reader are not reliable
- C. one operator is needed for each machine.
- D. the machine tool can easily overheat
- E. None of the above Discuss
- 6. A common data base is one requisite for converting CAD and CAM to CIM. Another is that:
Options- A. the system must make provision for new techniques.
- B. there should be a common 3-D part description system.
- C. the user must have access to both hardware and software
- D. technical assistance must be provided to the user.
- E. None of the above Discuss
- 7. Today's engineers feel that the ultimate solution to the CAD/CAM problem will be
Options- A. Animation
- B. the microprocessor
- C. turnkey systems
- D. development of a more efficient display controller
- E. None of the above Discuss
- 8. The electronic component that has been the key to recent developments in automation is the:
Options- A. improved vacuum tube
- B. integrated circuit
- C. diode
- D. transistor
- E. None of the above Discuss
- 9. The workspace required for a robot:
Options- A. is less than that of a human performing the same task
- B. depends upon the robot used
- C. is not dependent on the application.
- D. must be enclosed by a fence
- E. None of the above Discuss
- 10. Which of the following represents a conditional branching instruction?
Options- A. BGT LOOPS
- B. GOTO 50
- C. X = 5 + Y
- D. JMP MOTOR
- E. None of the above Discuss
Automation System problems
Search Results
Correct Answer: each operation in a sequence is continuous, but subsequent operations in the sequence may be different.
Correct Answer: a communications processor
Correct Answer: is widely used in industrial automation
Correct Answer: the value of the output never exceeds the value of the input during the transient period.
Correct Answer: the tape and tape reader are not reliable
Correct Answer: there should be a common 3-D part description system.
Correct Answer: the microprocessor
Correct Answer: integrated circuit
Correct Answer: depends upon the robot used
Correct Answer: BGT LOOPS
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.