Because the configuration infor-mation for a DHCP client is received dynamically, you must use which utility to read the current configuration to verify the settings?
Options
A. PING
B. TRACERT
C. ARP
D. IPCONFIG
E. None of the above
Correct Answer
IPCONFIG
Networking problems
Search Results
1. Which of the following statement is correct?
Options
A. Buffering is the process of temporarily storing the data to allow for small variation in device speeds
B. Buffering is a method to reduce cross-talks
C. Buffering is a method to reduce the routing overhead
D. Buffering is storage of data within the transmitting medium until the receiver is ready to receive
Correct Answer: TCP/IP is installed correctly on the client
3. You are working with three networks that have the network IDs 192.168.5.0, 192.168.6.0, and 192.168.7.0. What subnet mask can you use to combine these addresses into one?
6. The signal to noise ratio for a voice grade line is 30.1 dB (decibels) or a power ratio of 1023:1. The maximum achievable data rate on this line whose spectrum ranges from 300 Hz to 4300 Hz is
Correct Answer: a very common bit-oriented data link protocol issued by ISO.
9. Which of the following technique is used for Time-To-Line (TTL)?
Options
A. a technique used in best-effort delivery system to avoid endlessly looping packets.
B. a technique used by protocols in which a lower level protocol accepts a message from a higher level protocol and places it in the data portion of the low level frame
C. One of the pieces that results when an IP gateway divides an IP datagram into smaller pieces for transmission across a network that cannot handle the original datagram size.
This standard is part of a family of standards for local area networks (LANs) and metropolitan area networks (MANs) that deals with the physical and data link layers as defined by the ISO open systems interconnection reference model. It defines a high-speed shared medium access protocol for use over a dual, counterflowing, unidirectional bus subnetwork. The physical layer and distributed queue dual bus (DQDB) layer are required to support a logical link control (LLC) sublayer by means of a connectionless medium access control (MAC) sublayer service in a manner consistent with other IEEE 802 networks. Additional DQDB layer functions are specified as a framework for other services. These additional functions will support isochronous service users and connection-oriented data service users, but their implementation is not required for conformance.