Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs?
Options- A. DMA
- B. CMOS
- C. the OS
- D. configuration software
- E. None of the above
- Correct Answer
- configuration software
- 1. In which mode can 2 or more applications be stored in memory at the same time?
Options- A. Segmented Mode
- B. Unprotected Mode
- C. Real Mode
- D. Protected Mode
- E. None of the above Discuss
- 2. After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Options- A. MEM /P
- B. MEMMAKER
- C. MEM /C (A SYS:
- D. None of the above Discuss
- 3. How many pins on a VGA?
Options- A. 15.
- B. 9
- C. 25
- D. 32
- E. None of the above Discuss
- 4. To install a second IDE drive into a computer, you must:
Options- A. Set the master-slave jumper to slave on the second drive
- B. Use the IDE configuration software to set the new drive as slave
- C. Verify that you define the new drive as D: in the CMOS setup
- D. Verity that you attach the drive to the connector at the end of the ribbon cable
- E. None of the above Discuss
- 5. In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?
Options- A. Writing
- B. Transferring
- C. Conditioning
- D. All of the above
- E. None of the above Discuss
- 6. To prevent toner from sticking to a laser printer's heat rollers, apply which of the following:
Options- A. Alcohol
- B. Oil
- C. Ammonia
- D. Beer or Jack Daniels
- E. None of the above Discuss
- 7. During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
Options- A. +1000 volt
- B. +600 volts
- C. -600 volts
- D. -1000 volts
- E. + 12 volts Discuss
- 8. What is modified when changing the system start-up boot sequence?
Options- A. BIOS/CMOS
- B. CONFIG.SYS
- C. autoexec.bat
- D. COMMAND.COM
- E. None of the above Discuss
- 9. After doing a low-level format, what would be the next step in configuring the hard drive in a system?
Options- A. Format DOS partition
- B. Install operating system
- C. Configure DMA channel and back-up interrupt
- D. Partition hard disk
- E. None of the above Discuss
- 10. What is the best ground for a conductive work bench?
Options- A. AC outlet
- B. Ground to bend
- C. To another device
- D. Chassis ground
- E. None of the above Discuss
Computer Hardware problems
Search Results
Correct Answer: Protected Mode
Correct Answer: MEM /C (A SYS:
Correct Answer: 15.
Correct Answer: Set the master-slave jumper to slave on the second drive
Correct Answer: Transferring
Correct Answer: Oil
Correct Answer: -600 volts
Correct Answer: BIOS/CMOS
Correct Answer: Partition hard disk
Correct Answer: AC outlet
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.