Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?
Options- A. Writing
- B. Transferring
- C. Conditioning
- D. All of the above
- E. None of the above
- Correct Answer
- Transferring
- 1. When connecting a ribbon cable to a connector, how do you know which direction to plug it in?
Options- A. The red line in the cable goes to the highest pin number
- B. The colored line in the cable goes to pin #1
- C. It does not matter
- D. The blue or red line in the cable goes away from the power connector
- E. None of the above Discuss
- 2. RTS stands for:
Options- A. ready to start
- B. ready to switch
- C. request to send
- D. request to scan
- E. ready to set Discuss
- 3. In which mode can two or more applications be stored in memory at the same time?
Options- A. Segmented Mode
- B. Unprotected Mode
- C. Real Mode
- D. Protected Mode
- E. None of the above Discuss
- 4. Current is measured in units of:
Options- A. volts
- B. amps
- C. ohms
- D. farads
- E. diodes Discuss
- 5. You should never put floppy drives, hard drives, or even VCR tapes or cassette tapes on top of speakers (or near any other source of magnetism) because of:
Options- A. RFI
- B. EMI
- C. EXE
- D. FYI
- E. IOU Discuss
- 6. To install a second IDE drive into a computer, you must:
Options- A. Set the master-slave jumper to slave on the second drive
- B. Use the IDE configuration software to set the new drive as slave
- C. Verify that you define the new drive as D: in the CMOS setup
- D. Verity that you attach the drive to the connector at the end of the ribbon cable
- E. None of the above Discuss
- 7. How many pins on a VGA?
Options- A. 15.
- B. 9
- C. 25
- D. 32
- E. None of the above Discuss
- 8. After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Options- A. MEM /P
- B. MEMMAKER
- C. MEM /C (A SYS:
- D. None of the above Discuss
- 9. In which mode can 2 or more applications be stored in memory at the same time?
Options- A. Segmented Mode
- B. Unprotected Mode
- C. Real Mode
- D. Protected Mode
- E. None of the above Discuss
- 10. When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs?
Options- A. DMA
- B. CMOS
- C. the OS
- D. configuration software
- E. None of the above Discuss
Computer Hardware problems
Search Results
Correct Answer: The colored line in the cable goes to pin #1
Correct Answer: request to send
Correct Answer: Protected Mode
Correct Answer: amps
Correct Answer: EMI
Correct Answer: Set the master-slave jumper to slave on the second drive
Correct Answer: 15.
Correct Answer: MEM /C (A SYS:
Correct Answer: Protected Mode
Correct Answer: configuration software
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.