Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
Why does a successfully mapped network drive disappear every time you boot the computer?
Options- A. The computer you are connected to has moved
- B. You didn't click reconnect on log on
- C. The map statement is not in the autoexec.bat file
- D. The last drive was not set correctly
- E. None of the above
- Correct Answer
- The map statement is not in the autoexec.bat file
- 1. When you boot a PC and don't hear any beep, this could suggest which of the following?
Options- A. The monitor is turned off
- B. Keyboard not plugged in
- C. Normal PC boot
- D. Bad or disconnected speaker
- E. None of the above Discuss
- 2. You have a 15 pin female connector with the pins in two rows. What could you connect with this?
Options- A. Serial device
- B. Parallel device
- C. MIDI device
- D. Video device
- E. Joystick Discuss
- 3. When you are testing a fuse, you should set the Volt-OHM meter to what scale?
Options- A. AC
- B. DC
- C. AMPS
- D. OHMS
- E. None of the above Discuss
- 4. What is the most likely cause of an "FDD controller Failure" error message?
Options- A. you did not set the jumper on the floppy drive to drive A
- B. you forgot to flash CMOS
- C. you installed the floppy disk drive cable backward
- D. your computer's floppy drive is defective
- E. None of the above Discuss
- 5. WRAM is used on a
Options- A. modem
- B. video card
- C. motherboard
- D. ata connector
- E. None of the above Discuss
- 6. The 34-pin connection on an I/O card is for?
Options- A. floppy drive
- B. SCSI drive
- C. IDE drive
- D. zip drive
- E. None of the above Discuss
- 7. What command is used to hand up a MODEM when using the "AT Answer Command set"?
Options- A. ATZ
- B. ATD
- C. ATR
- D. ATH
- E. None of the above Discuss
- 8. Resistance is measured:
Options- A. in parallel
- B. in series
- C. after breaking the circuit
- D. after checking voltage
- E. after checking current Discuss
- 9. During boot-up, the memory test:
Options- A. Is a superfluous step that should be ignored
- B. Checks and verifies that contiguous memory is installed
- C. Is an operational error
- D. Displays what memory is installed, but nothing else
- E. None of the above Discuss
- 10. You run a super wing-ding diagnostic program on your PC, and it reports that your hard drive, microprocessor, RAM, and video card have seen better days. To resolve this problem you should:
Options- A. replace each part one at a time, rerunning the diagnostic before replacing the next part.
- B. check to see if you have a software problem
- C. replace everything at once and rerun the diagnostic
- D. get another copy of the diagnostic program
- E. run an exhaustive memory check Discuss
Computer Hardware problems
Search Results
Correct Answer: Bad or disconnected speaker
Correct Answer: Joystick
Correct Answer: OHMS
Correct Answer: you installed the floppy disk drive cable backward
Correct Answer: video card
Correct Answer: floppy drive
Correct Answer: ATH
Correct Answer: after breaking the circuit
Correct Answer: Is a superfluous step that should be ignored
Correct Answer: check to see if you have a software problem
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.