When you are testing a fuse, you should set the Volt-OHM meter to what scale? AC

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Computer Science ‣ Computer Hardware Comments

Question
When you are testing a fuse, you should set the Volt-OHM meter to what scale?
Options
A. AC
B. DC
C. AMPS
D. OHMS
E. None of the above

Correct Answer

OHMS

Computer Hardware problems

Search Results

1. What is the most likely cause of an "FDD controller Failure" error message?
Options
A. you did not set the jumper on the floppy drive to drive A
B. you forgot to flash CMOS
C. you installed the floppy disk drive cable backward
D. your computer's floppy drive is defective
E. None of the above

3. On a leased line installation a known good external modem shows no carrier detect light. Where is the problem most likely to be?
Options
A. In the modem
B. In the phone line
C. In the computer
D. In the DTC equipment
E. None of the above

4. After you service a laser printer, you notice dirty print. Which of the following would correct the problem?
Options
A. Clean the developer tank
B. Reset the printer
C. Run several blank pages
D. Clean the laser diode
E. None of the above

5. Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.
Options
A. bad data cable
B. incorrect jumper setting on drive
C. loose molex connector
D. virus
E. tfad system board

7. When you boot a PC and don't hear any beep, this could suggest which of the following?
Options
A. The monitor is turned off
B. Keyboard not plugged in
C. Normal PC boot
D. Bad or disconnected speaker
E. None of the above

8. Why does a successfully mapped network drive disappear every time you boot the computer?
Options
A. The computer you are connected to has moved
B. You didn't click reconnect on log on
C. The map statement is not in the autoexec.bat file
D. The last drive was not set correctly
E. None of the above

Comments

More in Computer Science: