logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Computer Hardware Comments

  • Question
  • Which step should you perform first before discharging a CRT?


  • Options
  • A. Remove the CRT from its housing
  • B. Disconnect the CRT from the computer
  • C. Remove the video assembly
  • D. Turn power off before removing power source
  • E. None of the above

  • Correct Answer
  • Turn power off before removing power source 


  • Computer Hardware problems


    Search Results


    • 1. A standard multimeter is ideal for measuring a monitors high voltage output.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. During the normal PC boot process, which of the following is active first?

    • Options
    • A. RAM BIOS
    • B. CMOS
    • C. ROM BIOS
    • D. Hard disk information
    • E. None of the above
    • Discuss
    • 3. A static jolt of as little of _____ volts can fry most any PC integrated circuit.

    • Options
    • A. 200
    • B. 30
    • C. 1000
    • D. 200
    • E. 500
    • Discuss
    • 4. An important first step in troubleshooting which component in a laser printer is causing a jam is to:

    • Options
    • A. note where in the paper path the paper stops
    • B. check all voltages
    • C. look up error codes
    • D. turn the printer off, then on again
    • E. remove the jammed paper
    • Discuss
    • 5. What voltage does a 586 system use?

    • Options
    • A. +12 volts
    • B. + 5 volts
    • C. + 8 volts
    • D. +3.3 volts
    • E. None of the above
    • Discuss
    • 6. Which I/O port belongs to LPT2?

    • Options
    • A. 378H
    • B. 278H
    • C. 3f8h
    • D. 2e8h
    • E. None of the above
    • Discuss
    • 7. All Operating Systems get their total memory initialized from?

    • Options
    • A. CPU
    • B. BIOS
    • C. ROM
    • D. RAM
    • E. None of the above
    • Discuss
    • 8. What Does EISA stand for?

    • Options
    • A. Extended Industry Standard Architecture
    • B. Expanded Industry Standard Architecture
    • C. Enhanced Industry Standard Architecture
    • D. Electronics Industry Standard Architecture
    • E. All of the above
    • Discuss
    • 9. How many DMA channels are in an AT-machine?

    • Options
    • A. 3
    • B. 4
    • C. 7
    • D. 8
    • E. None of the above
    • Discuss
    • 10. When a bearing in the power supply fan goes out, what should you replace?

    • Options
    • A. fan
    • B. case
    • C. bearing
    • D. power supply
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment