logo

CuriousTab

CuriousTab

Discussion


Home Electrical Engineering Series Circuits Comments

  • Question
  • The total resistance of a series circuit is equal to the difference between the largest and smallest value resistors.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • Series Circuits problems


    Search Results


    • 1. An RC differentiator acts as a

    • Options
    • A. low-pass filter
    • B. high-pass filter
    • C. band-pass filter
    • D. band-stop filter
    • Discuss
    • 2. Referring to the give circuit, the output will


    • Options
    • A. decay to zero at the end of the pulse
    • B. reach 6 V at the end of the pulse
    • C. reach 3.78 V at the end of the pulse
    • D. reach 5.16 V at the end of the pulse
    • Discuss
    • 3. The output of an RC integrator is taken across the

    • Options
    • A. diode
    • B. capacitor
    • C. resistor
    • D. source
    • Discuss
    • 4. A single 6 V pulse with a width of 600 µs is applied to an integrator consisting of a 150 kΩ resistor and a 0.002 µF capacitor. To what voltage will the capacitor charge?

    • Options
    • A. 0 V
    • B. 3.78 V
    • C. 5.16 V
    • D. 6 V
    • Discuss
    • 5. An integrator consists of a 3.3 kΩ resistor and a 2 µF capacitor. A single 30 V, 6 ms pulse is applied to the input. How much will the capacitor charge?

    • Options
    • A. 10.3 V
    • B. 30 V
    • C. 12.09 V
    • D. 17.91 V
    • Discuss
    • 6. The term series opposing means that sources are in series with opposite polarities.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. A series circuit acts as a current divider.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. A short in a series circuit prevents current.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. If you know the current anywhere in a series circuit, you know the current everywhere in a series circuit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. The voltage at one point in a circuit is always measured relative to another point.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment