CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Matching Questions Comments

Question

Match the following:

List I List II

A. SUS 1.

B. SBS 2.

C. SCS 3.

D. Shockley diode 4.

Options
A. A-1, B-2, C-3, D-4
B. A-1, B-3, C-4, D-2
C. A-4, B-2, C-3, D-1
D. A-1, B-2, C-4, D-3

Correct Answer

A-1, B-2, C-4, D-3

Matching Questions problems

Search Results

1. Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

Options
A. A-4, B-1, C-3, D-2
B. A-3, B-4, C-1, D-2
C. A-1, B-2, C-3, D-4
D. A-4, B-3, C-2, D-1

2. Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

Options
A. A-4, B-3, C-1, D-2
B. A-3, B-2, C-1, D-4
C. A-4, B-3, C-2, D-1
D. A-3, B-2, C-4, D-1

3. Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

Options
A. A-2, B-1, C-3, D-4
B. A-3, B-4, C-2, D-1
C. A-3, B-1, C-4, D-2
D. A-4, B-1, C-3, D-2

4. Match the following:

	List I		List II
A.	FM	1.	slope-overload
B.	DM	2.	? law
C.	PSK	3.	Envelope detector
D.	PCM	4.	Capture effect
		5.	Hilbert transform
		6.	Matched filter.

Options
A. A-5, B-1, C-6, D-4
B. A-4, B-6, C-1, D-5
C. A-4, B-1, C-6, D-2
D. A-6, B-3, C-4, D-2

5. Match the following:

	List I		List II
A.	Effective length of antenna	1.
B.	Capture area	2.
C.	Front to back ratio	3.

Options
A. A-3, B-2, C-1
B. A-2, B-3, C-1
C. A-1, B-3, C-2

6. Match the following:

	List I		List II
A.	Sky wave	1.	parasitic elements
B.	Antenna feed	2.	delta match
C.	Reflector	3.	long-wire antenna
D.	Rhombic antenna	4.	ionosphere

Options
A. A-1, B-3, C-4, D-2
B. A-2, B-1, C-3, D-4
C. A-1, B-2, C-3, D-4
D. A-4, B-2, C-1, D-3

7. Match the following:

	List I		List II
A.	? x = 0	1.	irrotational vector
B.	? . = 0	2.	conservative field
C.	? .dl = 0	3.	solenoidal vector

Options
A. A-3, B-1, C-2
B. A-1, B-2, C-3
C. A-2, B-3, C-1
D. A-3, B-2, C-1

8. Match the following:

	List I (Location of characteristics roots)		List II (System characteristic)
A.	(- 1 + j), (- 1 - j)	1.	Marginally stable
B.	(- 2 + j), (- 2 - j), (2, j) (- 2, j)	2.	Unstable
C.	- j, j - 1, 1	3.	Stable

Options
A. A-1, B-2, C-3
B. A-2, B-3, C-1
C. A-3, B-1, C-2
D. A-1, B-3, C-2

9. Match the following:

	List I		List II
A.	Digital counter	1.	Measurement of harmonics
B.	Schering Bridge	2.	Measurement of frequency
C.	Meggar	3.	Measurement of loss angle of dielectric
D.	Spectrum analyser	4.	Measurement of insulation resistance

Options
A. A-1, B-2, C-3, D-4
B. A-4, B-3, C-2, D-1
C. A-2, B-3, C-4, D-1
D. A-4, B-1, C-3, D-2

10. Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Bitwise inclusive OR
B.	&	2.	Bitwise AND
C.	\| \|	3.	Logical AND
D.	\|	4.	Logical OR

Options
A. A-1, B-2, C-3, D-4
B. A-3, B-2, C-4, D-1
C. A-2, B-3, C-1, D-4
D. A-1, B-4, C-2, D-3

Comments

More in Electronics and Communication Engineering: