Which of the following is a balanced line? Coaxial line Strip line Microstrip li

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments

Question
Which of the following is a balanced line?
Options
A. Coaxial line
B. Strip line
C. Microstrip line
D. TV twin lead

Correct Answer

TV twin lead

Microwave Communication problems

Search Results

1. Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is
Options
A. horizontally polarized
B. vertically polarized
C. polarized both horizontally
D. not polarized

3. A rectangular waveguide has two stubs each length connected at the source end. The stubs are short circuted. Then
Options
A. the longitudinal current is power current and current in stubs is reactive
B. the longitudinal current is reactive current and current in stubs is power current
C. both power and reactive exists in both longitudinal direction and stubs
D. the current in stubs is zero

4. Loading of a line means
Options
A. increasing inductance of line
B. increasing distributed inductance of line
C. decreasing distributed inductance of line
D. decreasing inductance of line

6. Consider the following statements
1. Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
2. For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
3. Ridge wave guide has higher conductor losser than a rectangular waveguide.
4. Ridge guide has higher conductor losser than a rectangular waveguide.
Which of the above statements are correct?
Options
A. 1 and 2 only
B. 1, 2 and 3 only
C. 2 and 3 only
D. All

8. In laboratory experiment the output from reflex klystron is moderated by square wave because
Options
A. it is easy to generate a square wave
B. crystal diode operates in square law region of i-v characteristics
C. it prevents frequency modulation
D. detector circuit is less complicated

9. In a TWT the loss in attenuator is
Options
A. almost equal to forward gain of tube
B. much less than forward gain of tube
C. much higher than forward gain of tube
D. almost infinite

10. For a waveguide, which of the following statements is wrong?
Options
A. It is usually made of brass or aluminium
B. It is usually rectangular or circular in shape
C. The dielectric region is usually air
D. The wall thickness is very small as compared to skin depth

Comments

More in Electronics and Communication Engineering: