In microwave detector used in laboratory measurements of relative power levels,

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments

Question
In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
Options
A. 0.1
B. 1.25
C. 5
D. 10

Correct Answer

1.25

Microwave Communication problems

Search Results

1. If a microstrip is enclosed in a metal enclosure
Options
A. the radiation losses are increased
B. the radiation losses are reduced RL
C. the capacitance becomes zero
D. the inductance becomes zero

2. Consider the following statements (L is the length of array between centres of end antennas and A is wave-length)
1. Width of major lobe between nulls of broad side array and end fire array are different.
2. Directive gain of broadside array and end fire array are different.
3. Directive gain of broadside array is 4
Which of the above statements are correct?
Options
A. 1, 2 and 3
B. 1 and 2 only
C. 1 only
D. 1 and 3 only

5. Which of the following are true for magic tee in the given figure select the answer as per given codes
1. S₁₃ = S₂₃
2. S₁₄ = S₂₄
3. S₁₂ = 0
4. S₃₄ = 0
Options
A. 1, 2 and 3
B. 1, 2 and 4
C. 2, 3 and 4
D. 1, 3 and 4

6. Loading of a line means
Options
A. increasing inductance of line
B. increasing distributed inductance of line
C. decreasing distributed inductance of line
D. decreasing inductance of line

7. A rectangular waveguide has two stubs each length connected at the source end. The stubs are short circuted. Then
Options
A. the longitudinal current is power current and current in stubs is reactive
B. the longitudinal current is reactive current and current in stubs is power current
C. both power and reactive exists in both longitudinal direction and stubs
D. the current in stubs is zero

9. Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is
Options
A. horizontally polarized
B. vertically polarized
C. polarized both horizontally
D. not polarized

Comments

More in Electronics and Communication Engineering: