Discussion
Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments
- Question
The electrical requirement on wall thickness of rectangular wave guide is
Options- A. wall thickness is more than skin depth
- B. wall thickness is less than skin depth
- C. wall thickness is equal to skin depth
- D. either (b) or (c)
- Correct Answer
- wall thickness is more than skin depth
- 1. Which of the following modes in circular waveguides are circularly symmetric?
Options- A. TE01
- B. TE02
- C. both (a) and (b)
- D. neither (a) nor (b) Discuss
- 2. Klystron amplifier is not used to amplifier very weak microwave signals due to
Options- A. low gain for weak signals
- B. low noise for weak signals
- C. high noise
- D. both (a) and (b) Discuss
- 3. In fibre optics the use is made of thin glass fibres for efficient transmission of light.
Options- A. True
- B. False Discuss
- 4. An electromagnetic wave can be completely guided by a dielectric rod or slab.
Options- A. True
- B. False Discuss
- 5. The earliest uses of electromagnetic waves were
Options- A. point to point communication
- B. radar
- C. both (a) and (b)
- D. neither (a) nor (b) Discuss
- 6. Which mode is called dominant mode in rectangular wave guide?
Options- A. TE01
- B. TE11
- C. TE10
- D. TE20 Discuss
- 7. Radar reciever has high sensitivity and low noise figure
Options- A. True
- B. False Discuss
- 8. Which of the following lines behaves as infinite line?
Options- A. a line terminated in inductance
- B. a line terminated in capacitance
- C. a short line
- D. a line terminated in z0 Discuss
- 9. Most electromagnetic transmission in rectangular wave-guide uses
Options- A. TE10 mode
- B. TE01 mode
- C. TE20 mode
- D. TE11 mode Discuss
- 10. A line of characteristic impedance 400 ? is terminated by a resistance of 400 ?. The reflected quantities are
Options- A. zero
- B. equal to incident quantities
- C. half the incident quantities
- D. double the incident quantities Discuss
Microwave Communication problems
Search Results
Correct Answer: both (a) and (b)
Correct Answer: high noise
Correct Answer: True
Correct Answer: True
Correct Answer: both (a) and (b)
Correct Answer: TE10
Correct Answer: True
Correct Answer: a line terminated in z0
Correct Answer: TE10 mode
Correct Answer: zero
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.