logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments
  • Question

  • Performance of a PIN diode switch is represented by


  • Options
  • A. insertion loss when switch is off
  • B. insertion loss when switch is on
  • C. insertion loss when switch is on and isolation loss when switch is off
  • D. insertion loss when switch is off and isolation loss when switch is on

  • Correct Answer
  • insertion loss when switch is on and isolation loss when switch is off 

    • Microwave Communication problems

    Search Results

    • 1. Microwaves

    • Options
    • A. get reflected by ionosphere
    • B. are absorbed by ionosphere
    • C. are neither reflected nor absorbed by ionosphere
    • D. are both reflected and absorbed by ionosphere
      • Discuss
    • 2. In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept

    • Options
    • A. equal to velocity of electron
    • B. slightly less than velocity of electron
    • C. slightly more than velocity of electron
    • D. equal to velocity of light in free space
      • Discuss
    • 3. At millimeter wavelength the favoured mode in circular wave guide is

    • Options
    • A. TE01
    • B. TE11
    • C. TE20
    • D. TE21
      • Discuss
    • 4. As frequency is increased, the skin effect

    • Options
    • A. increases
    • B. decreases
    • C. remains the same
    • D. either (b) or (c)
      • Discuss
    • 5. A PIN diode can be used

    • Options
    • A. as a shunt mounted switch
    • B. as a series mounted switch
    • C. both as series or shunt mounted switch
    • D. non of the above
      • Discuss
    • 6. The manufacturing technique used to manufacture strip type transmission line is

    • Options
    • A. photoetching technique
    • B. oxidation technique
    • C. cladding
    • D. epitaxial
      • Discuss
    • 7. In microstrip line has dielectric material most commonly used is

    • Options
    • A. silicon
    • B. rubber
    • C. plastic
    • D. bakelite
      • Discuss
    • 8. In the given figure power meters at A and B indicate 1 mW and 110 ?W respectively. VSWR of line is

    • Options
    • A. 1.5
    • B. 2
    • C. 2.5
    • D. 3
      • Discuss
    • 9. The earliest uses of electromagnetic waves were

    • Options
    • A. point to point communication
    • B. radar
    • C. both (a) and (b)
    • D. neither (a) nor (b)
      • Discuss
    • 10. An electromagnetic wave can be completely guided by a dielectric rod or slab.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.