CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Electronics and Communication Engineering
‣
Microwave Communication
Comments
Question
For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
Options
A. 1000 MHz
B. 5000 MHz
C. 14000 MHz
D. 140000 MHz
Correct Answer
14000 MHz
Microwave Communication problems
Search Results
1.
TE
01
mode of propagation of electromagnetic energy
Options
A. is merely the TE
10
mode rotated 90°
B. is merely the TE
10
mode rotated 180°
C. is the same as TE
10
mode
D. either (b) or (c)
Show Answer
Scratch Pad
Discuss
Correct Answer: is merely the TE
10
mode rotated 90°
2. A line is excited by a 100 V, 200 ohm source and is terminated by 100 ? resistance. If the voltage on line reaches steady value in 80
ns
, the natural resonant frequency is
Options
A. 100 MHz
B. 50 MHz
C. 12.5 MHz
D. 6.25 MHz
Show Answer
Scratch Pad
Discuss
Correct Answer: 12.5 MHz
3. In TE
10
mode of rectangular waveguide
Options
A. there is one half sine wave variation along
x
direction and one along
y
direction
B. there is one half sine wave variation along
y
direction and one along
x
direction
C. there is one full sine wave variation along
x
direction and one along
y
direction
D. none of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: there is one half sine wave variation along
x
direction and one along
y
direction
4. The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
Options
A. sphere
B. rectangle
C. square
D. ellipse
Show Answer
Scratch Pad
Discuss
Correct Answer: sphere
5. Reflection from the object to be measured is significant only when the wavelength is
Options
A. much bigger than the size of object
B. much smaller than the size of object
C. almost of the size of object
D. either (a) or (c)
Show Answer
Scratch Pad
Discuss
Correct Answer: much smaller than the size of object
6. A PIN diode can be used
Options
A. as a shunt mounted switch
B. as a series mounted switch
C. both as series or shunt mounted switch
D. non of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: both as series or shunt mounted switch
7. As frequency is increased, the skin effect
Options
A. increases
B. decreases
C. remains the same
D. either (b) or (c)
Show Answer
Scratch Pad
Discuss
Correct Answer: increases
8. At millimeter wavelength the favoured mode in circular wave guide is
Options
A. TE
01
B. TE
11
C. TE
20
D. TE
21
Show Answer
Scratch Pad
Discuss
Correct Answer: TE
01
9. In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
Options
A. equal to velocity of electron
B. slightly less than velocity of electron
C. slightly more than velocity of electron
D. equal to velocity of light in free space
Show Answer
Scratch Pad
Discuss
Correct Answer: equal to velocity of electron
10. Microwaves
Options
A. get reflected by ionosphere
B. are absorbed by ionosphere
C. are neither reflected nor absorbed by ionosphere
D. are both reflected and absorbed by ionosphere
Show Answer
Scratch Pad
Discuss
Correct Answer: are neither reflected nor absorbed by ionosphere
Comments
There are no comments.
Enter a new Comment
Save
More in Electronics and Communication Engineering:
Analog Electronics
Automatic Control Systems
Communication Systems
Digital Electronics
Electromagnetic Field Theory
Electronic Devices and Circuits
Exam Questions Papers
Matching Questions
Materials and Components
Measurements and Instrumentation
Microprocessors
Microwave Communication
Networks Analysis and Synthesis
Power Electronics
Radio Receivers
Satellite Communication
Signals and Systems