In microwave circuits, a mode transducer is used to change mode of wave transmis

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication See What Others Are Saying!

Question
In microwave circuits, a mode transducer is used to
Options
A. change mode of wave transmission
B. change direction of wave transmission
C. change polarization of wave transmission
D. change mode, direction or polarization wave transmission

Correct Answer

change mode, direction or polarization wave transmission

More questions

2. The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplification
Options
A. AB
B. BC
C. CD
D. BD

3. A matched generator (Z_g = Z₀) with 1 ? available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
Options
A. 0.5 W, 0.5 W, 0 W
B. 0 W, 0 W, 1 W
C. 0.33 W each
D. 0 W, 0.25 W, 0.25 W

5. A wire is carrying current I. The field intensity H at a distance r from the wire
Options
A. is directed towards wire
B. is directed away from wire
C. is tangential every where to a circle of radius r
D. none of the above

6. A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.
Options
A. Sun and satellite
B. Sun and Earth station
C. Satellite and Earth station
D. Sun, satellite and Earth station

7. Which of the following is non-saturating?
Options
A. TTL
B. CMOS
C. ECL
D. Both (a) and (b)

8. The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
Options
A. True
B. False

10. Selectivity varies with receiving frequency, frequency is raised.
Options
A. Somewhat better when the receiving frequency is raised
B. Somewhat better at intermediate frequency
C. Somewhat worse when the receiving frequency is lowered
D. Somewhat worse when the receiving frequency is raised

Comments

More in Electronics and Communication Engineering: