A rectangular wave guide has two stubs each of length connected at the source en

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments

Question
A rectangular wave guide has two stubs each of length connected at the source end. The stubs are circuited. Then the stubs present
Options
A. an infinite impedance in shunt with line
B. an infinite impedance in series with line
C. a zero impedance in shunt with line
D. a finite impedance in shunt with line

Correct Answer

an infinite impedance in shunt with line

Microwave Communication problems

Search Results

2. The following components are used to measure power output of a 2 kW TWT amplifier
1. TWT
2. Low pass/High pass filter
3. Low power 20 dB attenuator
4. 40 dB directional coupler with matched load
5. Power meter.
The correct sequence of connections of these components is:
Options
A. 1, 4, 2, 3, 5
B. 1, 3, 4, 2, 5
C. 1, 2, 4, 3, 5
D. 1, 4, 3, 2, 5

5. To ensure that only dominant TE₁₀ mode propagates in a rectangular waveguide, the operating frequency
Options
A. must be more than cutoff frequency of TE₁₀ mode
B. must be less than cutoff frequency of TE₂₀ mode
C. must be more than cutoff frequency of TE₁₀ mode and less than cutoff frequency of TE₂₀ mode
D. must be less than cutoff frequency of TE₁₀ mode

9. Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
Options
A. reduced losses
B. high bandwidth
C. reduced losses and low bandwidth
D. more losses and low bandwidth

Comments

More in Electronics and Communication Engineering: