logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Microwave Communication Comments
  • Question

  • A directional coupler is used to determine


  • Options
  • A. rv
  • B. rv and VSWR
  • C. L and C
  • D. wave velocity

  • Correct Answer
  • rv and VSWR 

    • Microwave Communication problems

    Search Results

    • 1. Radar is essentially an echo ranging system

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. In a microwave coaxial cable the inner conductor radius is a and inner radius of outside conductor is b. For TE11 mode the cut off wavelength is about

    • Options
    • A. a + b
    • B. p(a + b)
    • C. pa
    • D. pb
      • Discuss
    • 3. The attenuation characteristics of a loaded line is similar to that of

    • Options
    • A. low pass filter
    • B. high pass filter
    • C. band pass filter
    • D. band stop filter
      • Discuss
    • 4. For air filled circular waveguides

    • Options
    • A. the attenuation due to imperfect conducting walls is negligible
    • B. the attenuation due to imperfect dielectric is negligible
    • C. both the attenuation i.e. due to imperfect conducting walls and due to imperfect dielectric are significant
    • D. the total attenuation is almost zero
      • Discuss
    • 5. Consider the following statements about instrument landing system of aircraft

      1. It ensures correct landing under conditions of low visibility.
      2. It consists of runaway localizer, glide path equipment and marker beacons.
      3. It is basically a blind landing system.
      Which of above statements are correct?

    • Options
    • A. All
    • B. 1 and 2 only
    • C. 1 and 3 only
    • D. 2 only
      • Discuss
    • 6. A TR (transmitter receiver) tube has

    • Options
    • A. low loss for low power signals and high
    • B. high loss for low power signals and low loss for high level signal
    • C. low loss for both low level and high level signals
    • D. high loss for both low level and high level signals
      • Discuss
    • 7. Assertion (A): In TE10 mode the cutoff frequency of rectangular waveguide is where a is the broad dimension and c is velocity of light.

      Reason (R): TE10 mode is the dominant mode in rectangular waveguide.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
      • Discuss
    • 8. Which mode has the minimum cutoff frequency in rectangular wave guides?

    • Options
    • A. TE11
    • B. TE10
    • C. TE01
    • D. TE20
      • Discuss
    • 9. The radiation resistance of a doublet antenna of length dl is proportional to

    • Options
    • A. ? l
    • B. (? l)2
    • C. (? l)3
    • D. (? l)05
      • Discuss
    • 10. Assertion (A): A small section of high impedance line is equivalent to a series inductance.

      Reason (R): A small section of a low impedance line is equivalent to a series resistance.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.