The skin depth at 1000 MHz as compared to that at 500 MHz is

The action of varactor diode is due to the capacitance of depletion layer. The thickness of depletion layer depends on the reverse bias which should not cause breakdown.

The quantities required to be measured in microwave circuits are frequency, power and impedance.

Microwave frequency measurement is done by slotted line, resonant cavities and transfer oscillator.

Microwave power measurement uses bolometers and microwave power meters.

A self balancing bridge working on the principle of power substitution is commonly used.

Microwave impedance measurement is done by measurement of reflection coefficient and VSWR.

A slotted line and probe is a basic tool for these measurements.' Network analyser enables rapid impedance measurement over a broad frequency range.

The signal gets strengthened.